Tripp Lite BP36V33, BP36VXR, BP24V33 User Manual

Owner’s Manual

BP36VXR BP36V33

1111 W. 35th Street

Chicago, IL 60609 USA

Customer Support: [phone]

www.tripplite.com

BP24V33 BP36V27

BP Series External Battery Packs

FRANÇAIS: p. 3

ESPAÑOL: p. 6

INTRODUCTION

Tripp Lite BP Series External Battery Packs have output voltages of either 36 volts (BP36VXR,
BP36V33, BP36V27) or 24 volts (BP24V33) and are designed for use with various Tripp Lite UPS
systems equipped with external battery pack connectors that are color-coded Red (24 volt) or Grey
(36 volt). When used with the appropriate Tripp Lite UPS, they meet UL standard 1778.

GENERAL BATTERY PACK INFORMATION

The batteries in the BP Series Battery Packs will eventually wear out and be unable to provide
adequate backup times. The batteries used in the Battery Packs should only be replaced by factory
authorized service personnel.

Batteries are shipped charged. Because batteries present a risk of electrical shock and burn
from high short-circuit current, observe proper precautions. Use tools with insulated
handles. Remove metal objects such as watches and rings before working with batteries.
Never bridge battery terminals or allow objects to contact battery terminals: serious injury
could result. Confirm that the item to be powered is of the same voltage as the battery pack
(36V or 24V, depending on model) before connecting to battery pack. Sparks may result
during final battery connection. Replace batteries only with sealed lead-acid batteries of the
same number, type, voltage and amp hour. The batteries are recyclable. Proper disposal
of batteries is required; refer to your local codes for disposal requirements. In the USA only,
you may call 1-800-SAV-LEAD (1-800-728-5323) for complete recycling information.

Do not dispose of the batteries in a fire. Do not open the batteries. A risk of electrical shock
can be present with the batteries. Do not short or bridge the battery terminals with any object.
Do not open the Battery Pack for any reason. There are no user-serviceable parts inside the
battery pack.

CAUTION!

CAUTION!

INSTALLATION

BP Series Battery Packs are compact units shipped with the batteries installed for quick, easy
installation.

Stacking Battery Packs

All the BP Series Battery Packs except the BP36V27 are stackable. Indents on the top cover of each
stackable Battery Pack mate with the feet of other Battery Packs as they are stacked.

DO NOT stack the battery packs more than two (2) high. Use caution when lifting the
Battery Packs. Because of the considerable weight of all BP Series Battery Packs [BP36VXR:

185 lb. (84 kg.); BP36V33: 88 lb. (40 kg.); BP36V27: 58 lb. (26 kg.); BP24V33: 66 lb. (30
kg.)], at least two people should assist in lifting them. Because the Battery Packs will be

held from the bottom when lifting, care should be taken when setting them down to avoid
injury. Make sure the surface where the packs are installed is level and strong enough to
support the combined weight of the Battery Packs and the UPS.

200004007 BP Series manual revision.p65 4/27/00, 3:40 PM1

CAUTION!

1

Connecting Battery Packs

All BP Series Battery Packs have 18" output cords with 175-amp polarized plugs except the BP36V27,
which has a 50-amp polarized plug. The plugs for all models are color-coded by voltage: Red for 24
volt, or Grey for 36 volt. All models also have a color-coded (Red for 24 volt, Grey for 36 volt) input
connector—select models feature an input connector on a 3" cord for easier connection. Simply connect
your Battery Pack's output plug into your UPS's input connector. If you are "daisy chaining" multiple
Battery Packs for greatly increased runtime, connect the output plugs of all but the first Battery Pack
(which connects to the UPS) into the input connectors of the other Battery Packs.

Battery Plug

& Connector

When connecting Battery Packs, make sure they are connected to the same voltage input.

CAUTION!

24 Volt Battery Packs must be connected to 24 Volt Input; 36 Volt Battery Packs must be
connected to 36 Volt Input. Also, make sure the Battery Pack plug is connected to a Battery
Pack connector with the same color code (Red plugs must be connected to Red connectors;
Grey plugs must be connected to Grey connectors). Make sure that the battery packs are
approximately the same age. DO NOT plug a battery pack into itself.

Additional battery packs connect in parallel to each other, as the polarized connectors automatically
orient to the correct polarity upon connection. In this way, battery voltage is maintained, while
battery amp-hour capacity is increased proportionately, depending on the number of additional
packs installed.

Observe limits on operation from external batteries. The limits are listed next to the

CAUTION!

connector on the rear of the UPS. DO NOT connect more than the specified number of battery
packs to the UPS. DO NOT unplug external batteries from the UPS while the UPS is
operating, due to the possibility of arcing.

MAINTENANCE

The BP Series Battery Packs require no maintenance but should be kept dry at all times. Avoid
locations with high heat and/or humidity. The battery packs should be kept fully charged by being
connected to an active UPS system as described on the front of this instruction sheet and not left
in a depleted condition. Batteries left in a discharged state will suffer a permanent loss of capacity.

TROUBLESHOOTING

There are no user-serviceable parts inside the BP Series Battery Packs. DO NOT open the Battery
Packs for any reason. There is a fuse array inside the Battery Packs. If a heavy overload or short
circuit is encountered, the fuse will open (blow). A Battery Pack with a blown fuse will deliver no
output voltage at zero load. A qualified technician must replace the fuse, which is a standard
automotive type. Contact Tripp Lite Customer Support for additional information.

2-YEAR LIMITED WARRANTY

Seller warrants this product, if used in accordance with all applicable instructions, to be free from original defects in
material and workmanship for a period of 2 years from the date of initial purchase. If the product should prove defective
in material or workmanship within that period, Seller will repair or replace the product, in its sole discretion. Service
under this Warranty can only be obtained by your delivering or shipping the product (with all shipping or delivery
charges prepaid) to: Tripp Lite, 1111 W. 35th Street, Chicago, IL 60609. Seller will pay return shipping charges. Call
Tripp Lite at [phone] before sending any equipment back for repair.

THIS WARRANTY DOES NOT APPLY TO NORMAL WEAR OR TO DAMAGE RESULTING FROM ACCIDENT,
MISUSE, ABUSE OR NEGLECT. SELLER MAKES NO EXPRESS WARRANTIES OTHER THAN THE WARRANTY
EXPRESSLY SET FORTH HEREIN. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ALL IMPLIED
WARRANTIES, INCLUDING ALL WARRANTIES OF MERCHANTABILITY OR FITNESS, ARE LIMITED IN DURA­TION TO THE WARRANTY PERIOD SET FORTH ABOVE; AND THIS WARRANTY EXPRESSLY EXCLUDES ALL
INCIDENTAL AND CONSEQUENTIAL DAMAGES. (Some states do not allow limitations on how long an implied
warranty lasts, and some states do not allow the exclusion or limitation of incidental or consequential damages, so the
above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you may have
other rights which vary from jurisdiction to jurisdiction).

Tripp Lite; 1111 W. 35th Street; Chicago, IL 60609

WARNING: The individual user should take care to determine prior to use whether this device is suitable, adequate or
safe for the use intended. Since individual applications are subject to great variation, the manufacturer makes no
representation or warranty as to the suitability or fitness of these devices for any specific application.

Policy of Tripp Lite is one of continuous improvement. Specifications are subject to change without notice.

2