Tripp Lite 93-0163 User Manual

LIFETIME

Seller warrants
instructions,
for

its

lifetime.
workmanship
inits sole discretion.
your delivering or shipping the product (with
charges prepaid) to: Tripp

will

pay

return

sending any equipment back for repair.

THIS

WARRANTY

DAMAGE RESULTING FROM ACCIDENT, MISUSE, ABUSE OR
NEGLECI:

THAN

TO
WARRANTIES, INCLUDING ALL WARRANTIES

THE

THE

EXTENT

this

product,

tobe

free

from original defects

If

the product should prove defective in material or

within

that period, Seller

Service

shipping charges.

DOES

SELLER

WARRANTY

PROHIBITED

MERCHANTABILITY

THE WARRANTY PERIOD SET FORTH ABOVE; AND THIS

WARRANTY

CONSEQUENTIAL DAMAGES. (Some states
how long an implied warranty lasts, and some states do not allow the
exclusion or limitation of incidental or consequential damages, so the
above limitations or exclusions may not apply to you.
gives you specific legal rights, and you may have other rights

from jurisdiction to jurisdiction).

WARNING:

use

whether
Since individual applications are subject to great variation, the
manufacturer

fitness of these devices for any specific application.

policy

of ~ri~~ ~ite

subject to change without notice.

EXPRESSLY EXCLUDES ALL INCIDENTAL AND

The individual user should

this

device

makes

no representation or wa- to the suitability or

is

one of continuous improvement. Specifications are

LIMITED

if

used

under

Lite,

418

NOT APPLY TO NORMAL

MAKES

OR

NO EXPRESS WARRANTIES OTHER

EXPRESSLY SET

BY

FlTNJ3S, ARE

Tripp Lite

500

N.

Chicago, IL

WARRANTY.

in accordance with all applicable

in

material and workmanship

will

repair or replace the product,

this

Warranty,

W.

Illinois, Chicago,

Call

Tripp Lite at [phone] before

FORT^

APPLICABLE LAW, ALL IMPLIED

LIMlTED

Orleans

60610

take

is

suitable, adequate or

can

only

be obtained by

all

shipping or delivery

IL

60610. Seller

WEAR

HEREIN.

IN

DURATION TO

donot allow limitationson

This

care

to

determine

safe

for the use intended.

OR TO

EXCEPT

OF

Warranty

whichvary

prior to

-

TR1pp&!E

7wEaJwm

~ata

Datashield

&

~ommunicatlon ~ine

Surge Suppressors

DataShield data/communication line surge suppressors
data and communications equipment against AC transients caused by lightning,
electrostatic discharge and ground

lines

or chassis ground.

DataShield surge suppressors described here protect virtually any
networked equipment using

Ring,

RS232,

communication interfaces.

RS422/423/485,

surges

10

baseT, 10 base-2 and 10 base5 Ethernet, Token

dial-up modems, fax, T-1 lines and most other

that enter equipment from the signal

are

designed to protect

Installation

To install the DataShield surge suppressor, follow these steps:

1.

Make sure the computer, network device or other equipment is logged

Turn

network (if applicable).

2.

Disconnect

3.

Connect the DataShield surge suppressor directly to the equipment.

4.

Attach the green ground
equipment's chassis:
not provide or require

5.

Reconnect the cable to the DataShield surge suppressor.

The DataShield surge suppressor must

possible to the equipment to
the signal
protected equipment

install

the surge suppressor

A singleDataShield surgesuppressor is equivalent to approximately
of typical data

the cable from the equipment to be protected.

(Datashield surge suppressors

this

line

and

ground

be

kept

communidtion cable.

OFF power to the equipment.

!

wire

on the surge suppressor directly to the protected

with

"D

style connectors do

external grounding).

NOTE!

be

properly

be

protected. For best results, it

wire

(if

equipped)

as

short

as

possible, not

directly

to

the equipment,

NOTE!

grounded

between

the surge suppressor

to

exceed

as

noted above.

and

positioned

is

required that the length of

12

inches

(12").

three

OFF

as

It

is

and

the

dose as

the

best

to

feet (3')

ACAUTIONI

When properly

the dataline portion of your installation. Additional

3

@

Printed

on

recycled

paper

0295

protectionin the form of anISOBARmsurge suppressor
recommended for complete system/network protection. Contact Tripp

Service

at

(312)

installed,

755-5401

the DataShield surge suppressor will protect against

AC

surge suppression/power

or

Tripp

Lite

UPSsystem isstrongly

Lite

for more information.

surges

on

Customer

All

ruse

S~ecifi~~ti~~~

supp-n listed have component mporue the*

Descriptlon:

~ominal
Breakover Voltage:

of

Ins than 1 pico~cond

Peak Pulse Current: Model:

S~ecifjcaf ions

Model:

All surge ruppmron listed have component mponse timer

of

leu

Uun

1

pfcoccond

1

PukPulr Current

I

DHUB

DRS232

DTKNRNG

DSUTICSU

DTELZ

DB15AUI

RJ45, 8-port ethemet,
token ring

ASQOO/Sydx

hubs, repeaters, terminal

servm,

I

RJ45 protector for
on
Supplied

patch

RJ45

MU*,

twisted

cable.

ethemet,

RS422/423/485,

protector for

MAUs,

RS232

pair

(wires

with

4"

AS400/

Sys3xprotector fm

75 volts, protecting

wirc?s

etc.

I

1-8).

wires

RJ45

75 volts, protecting

NICs,

wires

hubs and routers, etc.
Supplied

with

4"

RJ45

patch cable.

RJ45

tokenringprotector for
AS400/svs3x.
repeaters, terminals, etc.
Supplied
cable.

L

RJS for
~o~edT-lw~td

digital

DSUa

patch cable.

RJ45/RJll dial-up
protector for
answering and fax

machines

RJ11 patch

MCs,

with('

data

service

Supplied

Supplied with 4'

cable.

RJ45

~PM

withCRJ45

modem,

SerialDB9RS232protec­tor for male or female
ports of data

terminal

lmm.

patch

(SUs/

-7.5

wires

60 volts, protecting

wires

260 volts, protecting
center

(2

IS

pins 1-9 and

and computing equip
ment including

PCs,
moderns, etc. (any male
or female 9 pin

DB15 ethernet
protector.

port).

AUI

75 and 18 volts,
protecting

802.3

1-8

1-8

12.3,6

volts, protecting

3,4,!5,6

1-8

4

wires

Calines)

volts, protecting

pins

chassii

all

IEEE

I

-

1

750

amps

340

amps

750 amps

750

amps

200 amps

250

amps

750 amps

DCATV

Serial DB25
protector
for male or female

(wires

RS

1-8,20)

ports

of data terminal and
computing equipment
including

PCs,

printers,

modems, etc.

Serial DB2S
protector

any

25

pin male or female

DWCE

lobase5

protection

(Pi

ports.

thick

with

RS232

1-25) for

coax

'W

type male/female
connectors.

lObase2 thin

protected
f/m/f).

IBM

3270 and

lines

lObase2 thin 'coax
protector (BNC

Also

protects

and

CCrV

.rwinarial

'

protector (m/f).

Coaxial protector for
TVs,

VCRs,

supplied

("F'

m/f).

"f"

Also

IBM

lines.

ASlroo

pro video

by

coax

(BNC

protects

CCrV

m/f).

3270

Sys3x

CATV

232

18

volts, protecting
pins
chassis

18 volts, protecting
pins 1-25 and

chassis

7.5 volts, protecting
center, shield and

chassii

7.5

center, shield and

75 volts, protecting
center, shield and
chassis

10 volb, protecting

both

shield and

75 volrs, protecting
center and shield
conductors

1-8,20 and

volts. protecting

signal

b,

chassis

jrSO

amps

Call Tripp Lite Customer Senrice at

(312)

755-5401

for additional

Tcnnlnal Strip, RS4221RS4231RS405 and ARCNm ~olullons.

applications

requiring

Multipart,