Page 1
PLUG-BUG 2
Instructions
1) Test the Plug-Bug 2 on a known good receptacle before using on other receptacles.
2) Insert Plug-Bug 2 into receptacle to be tested and observe lights. Refer to Chart
below or on tester for results
3) If testing a GFCI protected receptacle, insert Plug-bug 2 into receptacle and observe lights.
AC power must be present in order to test a GFCI. The receptacle must be wired correctly
before proceeding (see Chart). If no lights come on, AC power is not present or the receptacle
is improperly wired. If lights indicate proper wiring, press the Plug Bug 2’s TEST button. If the
GFCI is working, the Plug-Bug 2’s indicator lights will turn off. The TEST LED may flash briefly.
If the indicator lights do not turn off, and the TEST LED remains lit, the GFCI is not working, or
the circuit being tested is not GFCI protected. (Do not press the TEST button for more than
6 seconds). To re-apply power to the GFCI protected circuit, press the RESET button located
on the receptacle or the GFCI circuit breakers.
Reason for
Cautions/Warnings
- 120 VAC is dangerous and may cause
user injury or death. Use all appropriate
cautions.
- Use only on 110 to 125 VAC receptacles
- Test the Plug-Bug 2 on known good
receptacle before using on other
receptacle
- GFCI receptacle or GFCI branch circuit
protector must be installed in accordance
with the manufacture’s specifications.
Indicator Fault
Open
Ground
Open
Neutral
Open
Hot
Hot / Ground
/ Reverse
Hot / Neutral
/ Reverse
Correct
Wiring Fault
Ground contact not
connected
Neutral contact not
connected
Hot contact not connected
Hot and Ground
contacts interchanged
Hot and Neutral
contacts interchanged
Receptacle is wired correctly
- Do not press the TEST button on the
Plug-bug 2 for more than 6 seconds
- This tester will not accurately indicate
a combination of wiring problems.
- To help avoid erroneous readings, all
appliances and equipment must be
unplugged / disconnected from the
circuit being tested.
- This tester does not perform a
comprehensive test. Its only checks
for probable common improper
wiring conditions.
- This tester does not indicate the quality
- This tester does not determine if the
neutral and ground conductors are
reversed
- This tester will not test GFCI’s installed
on 2 wire (non-grounded) electrical
circuits.
- All corrective action must be made by
qualified electrician
of a ground connection.
- This tester may not indicate the presence
of a hot wire. That is, it is possible for a hot
Do Not Throwaway
wire to be present when none of the
indicators light.
Find Quality Products Online at: sales@GlobalTestSupply.com
Please refer to this manual per each use of this product
www.GlobalTestSupply.com
PN: 9610
Loading...