Page 1
Sni-It Specications:
RI SK OF ELECTRIC AL SHOCK
Turn power off before i nspection, i nstallation or
removal of battery. Ke ep away from childr en. Do
not use in wet locations.
RI ESGO DE DESCAR GA ELÉCTR ICA
Apage el p oder ant es de la inspecció n, l a
instalac ión o el retiro de batería. Guarde
(mantenga) de distancia de niños. No use en
posiciones mojadas.
RI SQUE DE CHOC ÉL ECTRIQUE
Éteignez le pouvoir( la puissance) avant
l'i nspection, l'i nstalla tion ou l
e déplacement de
batterie(pile). Tenez l oin d'enfants. N'utili sez pas
dans des emplacements humides.
GEFAHR DES ELEKT RIS CHEN SCHLAGES
Drehen Si e Kraft vor Bes ichtigung, I nstallation o der
Wegschaffen der Batterie ab. B leiben S ie weg von
Kindern. Gebrauchen (benutzen) Si e in n assen
Lokationen nicht.
Voltage for Transmitter:
90-250 VAC
Operating Frequency:
50 - 60 Hertz
Storage Temperature:
Operating & Detection
1) Install a fresh 9-volt alkaline battery (not included) in the RECEIVER.
2) Plug the TRANSMITTER into a live wall outlet or a light socket adapter (Kit sold separately) on the circuit
you wish to identify. If the circuit is not yet connected to a wall outlet or light socket, plug the TRANSMITTER
into the Alligator Lead adaptor (Kit sold separately) and clip the leads to the wires. Once the TRANSMITTER
is connected to the circuit, the LED will glow, indicating power.
3) Turn the RECEIVER power ON by pressing the power button once. The RECEIVER will beep and the arrow
will flash. The LED above the button will remain on. Do not hold the power button down to run the
test.
4) At the breaker box or fuse box, hold the RECEIVER PERPENDICULAR to the breakers. With the power on,
scan the rows of breakers from top to bottom. During this scan, the RECEIVER may beep and flash at several
breakers. This is a normal part of the identification process. When you have completed one scan of all of the
breakers, go back to the first breaker and, without touching the power button, scan them all a second time.
When the receiver beeps and the arrow flashes during the second scan, you have correctly identified the circuit.
5) When you have finished, turn the RECEIVER off by pressing and holding the power button until the LED
above the button turns off. Beeping and flashing of the RECEIVER during shutdown is normal. The RECEIVER
will also turn itself off after several minutes of inactivity. Always remember to unplug the TRANSMITTER
when you have finished.
32 to 105 degrees F.
Operating Temperature:
32 to 105 degrees F.
Sensitivity Adjustment:
Automatic
Power Supply:
9-Volt Alkaline Battery.
(Receiver Only)
Transmitter Polarity:
Automatic
Humidity:
50% RH maximum
(non condensing)
Environmental Conditions:
For Indoor use
For Altitudes up to 6000 ft.
Pollution Degree 2
Installation Category II
Caution:
79-796 cord assembly
to be used with Sni-It
Transmitter only
according to instructions.
WARNING! ¡ADVER TENCIA!
AVERTISSE MENT! WARNUNG!
Loading...