BluCube MANUAL GUIDE
INSTRUCTION
Charging:
• Your BluCube uses a rechargeable battery. Fully charge
battery before using. Please turn OFF before charging.
• Use the USB cable provided to connect to any
computer /notebook or USB power adaptor. When
charging, the red indicator light will appear.
• When fully charged, the red indicator light will turn
off.Charging time: Approximately 2 hours. Turn BluCube
off when not in use to save battery life. (You BluCube will
beep every 30 seconds while playing music when the
battery is low. Please recharge it for continuous use.)
Pairing device with your BluCube:
• Before using the BluCube, please pair it with your
smartphone, MP3 player, computer or any
Bluetooth-enabled device.
• Set your Bluetooth device to discover the BluCube by
following the instruction manual for your device.
Typically the steps are going to “Setup” “connect” or
“Bluetooth” menu and then selection to discover
Bluetooth devices.
• Turn the BluCube ON. Speaker will automatically begin
pairing. The blue indicator light will flash quickly, this
indicating “in pairing mode.”
• When your Bluetooth-enabled device discovers the
BluCube, press “OK” to pair with the BluCube. Blue
indicator light will switch to slow blinking to indicate
pairing is successful.
Troubleshooting:
• If Bluetooth-enabled device fails to locate the BluCube,
check that the speaker is ON. Ensure that your device is
within range (within 30 feet/10 meters). Restart your
BluCube to reactivate Bluetooth pairing mode. Ensure
that your speaker is not connected or paired to any other
Bluetooth device as the BluCube can only be paired to
one device at a time.
Playing music:
• After pairing is established, you can play music from
your Bluetooth enabled device. Music and volume can be
controlled by your device. You BluCube will play up to 7
hours depending on volume level.
How to use Line-In function:
• If you have a device that in not Bluetooth-enabled and
you would still like to use it with the BluCube, you can!
The enclosed 3.5mm audio cable can connect to your
non-Bluetooth enabled devices.
• Turn the BluCube ON and plug the 3.5mm audio cable
into the “Line-in” port.
• Plug the other end to your device. Music and volume
can be controlled by your device.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Loading...