Trinx ICAN1421 Owner Manual

Page 1
RECOMMENDED TOOLS
CANVAS CARE GUIDE
Hammer Towel Ice cube
FIXING LOOSE CANVAS
Stand piece of art upright on a hard surface and place a piece of cloth between the art and the surface to protect both.
FIXING INDENTATIONS & CREASES
In the corners of the canvas on the back, you will notice two wedges in each corner that allows you to adjust the tension by slightly tapping on them with a hammer.
B
A
Tap down on the stretcher wedges with a hammer where the arrows point. Rotate canvas to always be tapping downward towards the hard surface. Tap until you see the frame begin to split further apart. Repeat process until canvas is pulled taut.
FIXING WARPED FRAME
A
B
D
C
Warped frames can be easily fixed by bending them back.
Let dry for 15-20 minutes and the crease or indentation should go away. Avoid over saturating, or canvas may need to dry for a while longer.
A
Place the art along a table’s edge as shown. Place your hands on the corner that was coming away from the wall and its opposite corner. Gently push down on the corners to stretch the canvas diagonal. Hang your art piece on the wall and test. If still coming away the from wall, repeat steps.
NEED HELP?
If you do run into any trouble, please don’t hesitate to contact us: Phone: 800-980-1089 | Email: support@icanvas.com
C
Bad corner
B
D
NOTE: It is normal to hear the wood slightly splintering.
B
C
Loading...