Trim-Tex LED Light Bead User Manual

Installation Instructions

LED Strip

Please read entire instruction before proceeding.

Improper installation will void any applicable warranty.

The Trim-Tex LED Light Bead is a rigid vinyl product that installs
directly to the drywall and has an angled leg that allows you to install
LED strip lighting at the optimal light angle. It accommodates low
profile " wide LED strips. The angled leg also creates a crisp line⅜
and accent shadow for a sharp clean look. The bead mud leg allows
the bead to seamlessly blend into your drywall. Use it in hallways,
elevator lobbies, conference rooms, decorative soffits or anywhere
you want to add LED lighting as an accent.

The optimal distance from the ceiling is 2" - 5" depending on the
LED wattage.

L.E.D. Light Bead

Stock No.

LED10

T P E LED L BHE OSSIBILITIES ARE NDLESS WITH IGHT EAD

LED Strip

Drywall

2" x 2" 2" x 2"

Soffit Detail

2" x 2"2" x 2"

Length

10'

Drywall Ceiling

LED Light Bead

350 Chamfer Bead

Chamfer Bead

Pcs Per Box

20

2" x 2" 2" x 2"

Light Cove Detail

2" x 2"

2" x 2"

Single Layer

Detail

Chamfer Stop

INSTALLATION: Dry fit and cut the LED Light Bead to length. The LED Light Bead has a
⅝½" return leg so it will not work with " Drywall. Spray the bead and drywall with Trim­Tex 847 Spray Adhesive & immediately apply to the drywall. Once in position, press the
leg into place using the Trim-Tex installation tool or handle of your taping knife. Staple
the mud leg every 6"-8" with ½" long divergent staples. Finish the installation by mudding
and sanding the bead.

Don’t settle for a boring square soffit. Chamfer bead is just one of 11 different

ways to decorate your soffits and light coves.

www.trim-tex.com • 3700 W. Pratt Ave. Lincolnwood, IL 60712-2508 • Phone: [phone] • Fax: [phone]