OLYMPIA Board Description
CPU information memory information jumper settings CMOS SETUP
Jumper Settings on the OLYMPIA Board
CPU settings
jumper setting function
JP1
1-2 Select 486DX, 486DX2
2-3 Select 486SX PGA-Type CPU
JP6, JP7
1-2* Select 486SX, 486DX, 486DX2
JP12
2-3
Select P24D or P54T
JP8, JP9
1-2*
Select EPROM BIOS
2-3
Reserved
JP10,JP11
1-2
DRQ1,DACK1# in ECP, EPP mode
2-3* DRQ3,DACK3# in ECP, EPP mode
SW1
CPU clock setting (25 MHz) CPU clock setting (33 MHz)
SX/25, DX/25, DX2/50 SX/33, DX/33, DX2/66
1 ON OFF
2
OFF ON
3
ON ON
DIP switch settings related to password and video usage on the main board
SW1 setting function
4
ON*
When using a password
OFF If no password is used
5
ON* Color video card selection
OFF Choose a mono video card
6
ON* When using the built-in video adapter
OFF If you are not using the built-in video adapter
cache memory settings
jumper
0KB 128KB
256KB
JP2 1-2 2-3 2-3
JP3 1-2 1-2 2-3
JP4 1-2 2-3 1-2
JP5 1-2 1-2 2-3
Resolution-related jumper settings for your monitor
jumper function
VJ1 VJ2
800*600 Vertical Refresh Rate
1-2* 1-2*
800*600 in 2, 16, or 256 colors, 56Hz
1-2 2-3
800*600 in 2, 16, or 256 colors, 60Hz
2-3 1-2
800*600 in 2, 16, or 256 colors, 72Hz
2-3 2-3 800*600 in 2, 16, or 256 colors, 56Hz
jumper function
VJ3
VJ4 1024*768 Vertical Refresh Rate
1-2*
1-2*
1024*768 in 2, 16, or 256 colors, Interlaced
1-2 2-3 1024*768 in 2, 16, or 256 colors, non-Interlaced
2-3 1-2 1024*768 in 2, 16, or 256 colors, non-Interlaced
2-3 2-3 1024*768 in 2, 16, or 256 colors, non-Interlaced
OLYMPIA board CPU support
Supportable CPU
The following PGA type CPUs are supported, all operating at 5V
SL Enhanced Intel486SX-25MHz
SL Enhanced Intel486SX-33MHz
SL Enhanced Intel486DX-25MHz (embedded coprocessor)
SL Enhanced Intel486DX-33MHz (with coprocessor)
SL Enhanced Intel486DX2-50MHz (embedded coprocessor)
SL Enhanced Intel486DX2-66MHz (embedded coprocessor)
P24D & P24T
Memory Support on OLYMPIA Boards
cache memory
Capacity: Use 0 KB, 128 KB or 256 KB
main memory
Type: 72-pin SIMM module (32-bit-no-parity memory available)
Speed: 70ns
Capacity : 4MB,8MB,16MB,32MB available
Expansion: Up to 64MB
memory size Bank 0 (SIMM1) Bank 1 (SIMM2) Bank 2 (SIMM3) Bank 3 (SIMM4)
4M 4M -- -- --
8M
4M 4M -- --
8M -- -- --
12M 4M 4M 4M --
16M
4M 4M 4M 4M
8M 8M -- --
16M -- -- --
20M 4M 16M -- --
24M
4M 4M 16M --
8M 8M 8M --
32M
8M 8M 8M 8M
16M 16M -- --
32M -- -- --
36M 4M 16M 16M --
40M 4M 4M 16M 16M
48M 16M 16M 16M --
64M
16M 16M 16M 16M
32M 32M -- --
OLYMPIA Main B/D CMOS SETUP
use key
Enter or 1 ~ 8 Execute
arrow keys Select
Esc Save & Exit
Press the DEL key during booting
Level 1 Step 2 Step 3 Step 4 optional
1. STRAT OPERATING SYSTEM: System reboot progress
2. RUN EASY KOREAN CMOS SETUP
Korean setup screen provided (date, time, A: B: floppy disk, C: D: hard disk, password
can be set)
3. Run CMOS Setup Execute setup screen
Date(mm /dd/yy)
Wed, Sep 21 1997) date
Time(hour/min/sec)
10 : 22 : 19 hour
Floppy drive A
1.2MB, 5 1/4 Not.., 360KB 5 1/4, 1.2MB 5 1/4
Floppy drive B
Not Installed Not.., 720KB 3 1/2, 1.44MB 3 1/2, .88MB 1/2
A: and B: switching
Disabled Disabled/enabled
Hard disk C: Type
36 1~ 47(USER TYPE)/Not Installed
Hard disk D: type
Not Installed
Primary display
VGA/PGA/EGA
VGA/PGA/EGA, Mono.., Color 40x25, Color 80x25, Not
Installed
System speed
Fast Fast/Slow
Booting sequence
A: then C: A: then C:/C: only
Diskette seek test
Disabled Disabled/enabled
Base memory xxx KB
Ext. memory xxxx KB
Coprocessor Not Installed
[Power Management setup]
PM Mode
Enabled Enabled/Disabled
Standby After
2Min 10sec ~ 2hour/Disabled
Suspend After
10Min 20sec ~ 20hour/Disabled
Video Activity
Detection
Disabled Enabled/Disabled
[ Shadow & Cache setup ]
System BIOS Shadowed
Video
BIOS
Enabled Enabled/Disabled
C8000CFFFF
Disabled Disabled/Enabled
D0000D7FFF
Disabled Disabled/Enabled
D8000DFFFF
Disabled Disabled/Enabled
Ext. Cache
Disabled Dissbled/Enabled
[ Peripherals setup ]
Parallel
U-LPT1 U-LPT/B-LPT
Serial
COM1 + 2
PS/2 Mouse
Enabled Enabled/Disabled
FDC
Enabled Enabled/Disabled
IDE
Enabled Enabled/Disabled
[ Keyboard setup ]
Test
Enabled Enabled/Disabled
NumLock
On On/OFF
Key rate
30 2 ~ 30
Key Delay 0.25
4. CMOS PASSWORD SETUP password setting
Password state
Not Installed Not../New../ Installed
Hot Key state
Not Installed Not../New../ Installed
Boot Password
Disabled Disabled/Enabled
CMOS Password
Disabled Disabled/Enabled
5. DISPLAY MAIN BOARD HELP
DIP switch, jumper, HDD capacity and type, memory bank composition, and cache memory
information display
6. LOAD DEFAULT VALUES TO CMOS 'CMOS SETUP' and 'CMOS PASSWORD SETUP' changed to initial values.
7. WRITE(SAVE) TP CMOS AND EXIT Save the current setup and reboot
8. DO NOT WRITE TO CMOS AND
EXIT
현재 설정된 셋업 내용을 저장하지 않고 재부팅
{button OLIMPIA 관련 항목 보기, Klink(OLIMPIA)}
Loading...