Trieste ED-PF180L Instruction Manual

1

Trieste

Instruction Manual

Upright Freezer

MODEL: ED-PF180L

2

Dear customer:

Thank you for buying this upright freezer. To ensure that you
get the best results from your new freezer, please take time to
read through the simple instructions in this booklet.

Please ensure that the packing material is disposed of in
accordance with the current environmental requirements.

When disposing of any fridge equipment please contact your
local waste disposal department for advice on safe disposal.

This appliance must be only used for its intended purpose.

INSTALLING YOUR REFRIGERATOR

User should take out the door handle in the plastic bag, and install it
into the door. Then take out the two handle stopples and cover the
installed screws with them. The handle stopple and screw stopple in the
plastic bag can be used when the user wants the door to be opened from
left.

UNPACKING YOUR REFRIGERATOR

WARNING: Use two or more people to move fridge.

Failure to do so can result in back or other injury.

·Remove tape and any labels from your fridge before using(except
the rating label).

To remove any remaining tape or glue, rub the area briskly with
your thumb.

3

Tape or glue residue can also be easily removed by rubbing a

small amount of liquid dish soap over the adhesive with your
fingers. Wipe with warm water and dry.

·Do not use sharp instruments, rubbing alcohol, flammable fluids, or
abrasive cleaners to remove tape or glue. These products can
damage the surface of your refrigerator.

·When moving the refrigerator, do not tilt the refrigerator beyond 45°

from upright position.

CLEANING BEFORE USE：

After you remove all of the packaging materials, （especially the
foam between outside condenser and cabinet should be removed）
clean the inside of your fridge before using it.

SPACE REQUIREMENTS

WARNING: Keep flammable materials and vapors, such as
gasoline, away form fridge.
Failure to do so can result in death, explosion, fine or burns.

·To ensure proper ventilation for your fridge, allow for 200mm space
on each side between walls, 100mm space between back of your
fridge and the wall, and 300mm space between counter top and
the roof or ceiling.

·If you are installing your fridge next to a fixed wall, leave sufficient
space on the hinge side to allow for the door to swing open.

·Never install your fridge near heat source and direct sun shins.

ELECTRICAL REQUIREMENT

WARNING: DO NOT REMOVE GROUND PRONG.

DO NOT USE AN ADAPTOR.