b) Power wheelchair dynamical and control system requirement and
testing method. (ISO 7176-14)
c) Power wheelchair climatic experimental method. (ISO 7176-9)
d) cushion fire resistance requirement and testing method.
( ISO 7176-16)
3. Key Components
Handlebar Controls
Battery Indicator 21
Speed Control 20
Keyed Ignition 18
4. Operating Instructions
Turning on the Power ( 18 )
Turn battery switch to on position. The battery is on when the switch is pressed toward the
“-“ position.
Push the key down into the keyed ignition and the power will
turn on. Pull the key out of the keyed ignition to turn power off.
Please Note:
1. The TRIAXE CRUZE will not move if the Free Wheel Lever is in the
release position. (11)
2. The Safety Anti Tip Rear Wheels Need to be in the Down
Position on both sides when driving the scooter.
Free Wheel Lever ( 11 )
Fingertip Controls 19
Headlight
On/Off Switch 23
Horn 22
The free wheel lever allows the scooter to be easily pushed forwards and
backwards. It is located on the rear of the scooter on the right-hand side. When
the lever is in the release position the wheels are able to freely move. The free
wheel lever must be in the locked position to drive the scooter. To change the free
wheel lever, remove the key and move the free wheel lever to the desired
position. When the lever is in the desired position, put the key back in the
scooter.
Please note:
1. If the key is in the on position when disengaging the Free Wheel Lever you must
remove the key to power off and then push the key in again for the CRUZE to
move.
2. When the Free Wheel lever is in the lock position, the CRUZE will suddenly slow
down if pushing or pulling the scooter too fast.
3. There will be a series of rapid beeps if the key is inserted and the free wheel
lever is in the release position.
The Handlebar Control consists of a keyed ignition 18, fingertip
controls 19, speed potentiometer 20, Battery Indicator 21, horn
21 and headlight on/off switch 22.
Free Wheel Lever 11
Push up to Release
Push down to lock