
Led Sunflower
Copyright triAngle lights
Last updated on Mach 28th 2013
triangle.lights@gmail.com
1/5 Copyright 2013 triAngle lights
1. INTRODUCTION
Please read this user manual carefully and thoroughly before
operation.
1.1 What is Included
a) 1X led sunflower with lead
b) 1X user manual
Carefully unpack the carton, check the contents to ensure that all
parts are present and in good condition. Contact your supplier if any
part is missing or damaged.
1.2 Safety Instructions
▪ This product is intended for indoor use only!
▪ Always turn off, unplug power and allow fixture to cool before
servicing.
▪ Ensure that fixture is properly grounded.
▪ Please keep this User Guide for future reference.
▪ Always make sure that you are connecting to the proper voltage
and that the line voltage you are connecting to is not higher than that
stated on decal or rear panel of the fixture.
▪ To prevent risk of fire or shock, do not expose fixture to rain or
moisture.
▪ Make sure power cord is never crimped or damaged.
▪ Do not look into the beam from a distance of less than 40 cm (16
inches).
WARNING!!! To reduce risk of fire, electric shock, or
injury, follow these important safety instructions

2/5 Copyright 2013 triAngle lights
1.3 Product Features
▪ 48x5mm RGB leds (red:16, green:16, blue:16)
▪ 2 modes: Auto, Sound Active
2. SET UP
2.1 Mounting
With adjustable mounting double brackets, this unit may be wall
mounted, free standing, or clamp mounted.
IMPORTANT!!! Safety cables must always be used. The safety
cable must be capable of holding 10 times the weight of the
fixture.
2.2 AC Power
The fixture is designed to work on 100V-240V 50/60Hz.
Warning!!! All fixtures must be connected to circuits
with a suitable Earth Ground.
3/5 Copyright 2013 triAngle lights
3 OPERATION INSTRUCTIONS
3.1 Sound Mode and Auto Mode
The unit will run in sound active mode by default. If there is no music it
will switch to Auto mode automatically.
It will go into sleep mode after 5 minutes of auto run to save power.
Sound mode can be activated again from sleep mode via any sound
such as music, clap, or voice.
4.SERVICING
4.1 Fuse Replacement
1. Unscrew the fuse holder and remove the damaged fuse.
2. Replace with exact same type fuse and screw the fuse holder back in
its place.
4.2 Cleaning
To maintain optimum performance fixtures should be cleaned
frequently.
Unplug fixture from power and allow the fixture to cool down. Use a
vacuum or air compressor and a soft brush to remove dust collected on
the plastic cover or lens.

4/5 Copyright 2013 triAngle lights
5.TECHNICAL SPECIFICATIONS
WEIGHT&DIMENSIONS
AC Power AC110-240V 50/60Hz
I
MPORTANT INFORMATION!
In order to optimize the recovery and recycling of the materials that
old appliances contain and reduce the impact on human health
and the environment, ensure that this product is recycled at the
end of its life.