Page 1
Triad OnWall Products w/ EasyMount Bracket - Quick Start Guide
2014.2.1
Specifications
Applicable Models Dimensions Frequency Response Sensitivity Rec Amp Pwr Rec Sub Xover Impedance Weight lbs/kg
Inches / cm +/-3dB, 4pi* 2.83v, 1m Per Channel Nominal
OnWall Bronze LCR 10x28x4; 25.4x71.2x10.2 80 Hz - 20 kHz 90 dB 50-200 Watts 80-90* Hz 4 ohms 16.5 / 7.5
OnWall MiniSat 3.0 44x6x2.8; 111.8x15.2x7.3 112 Hz - 20 kHz 85 dB 25-75 Watts 120 Hz 8 ohms 15.2 / 6.9
*4 pi Frequency Response specifications are measured in Full Space with no walls or other boundary reinforcements nearby. Use 80Hz sub crossover if mounted against a wall, 90Hz if away from wall.
Additional Info
Triad's EasyMount wall bracket, included with each speaker, is quick & easy to install, adds no depth, and allows up to .5 inch (12.7mm) horizontal and vertical adjustments for
leveling or aligning.
North American Limited Warranty
Triad speakers are warranted to be free from defects in manufacturing and workmanship (10) years when operated under normal conditions. Should any such defects occur within
the warranty period call Triad Service at 1-877-264-6315 for an RA (Return Authorization) number. Return the product in intact factory packaging with RA number clearly visible on
outside of box and proof & date of purchase inside to:
Triad Speakers Inc., 15835 NE Cameron Blvd., Portland, Oregon 97230 USA
Triad is not responsible for any shipping damage coming in to Triad. If you do not have intact factory packaging, contact your dealer or Triad Service for purchase. At our discretion
we will repair or replace the product and return it free of charge. International customers should contact their dealer for service. This limited warranty is extended only to Triad
products and is expressly in lieu of all other warranties expressed or implied.
Unpacking / Contents
x2 x2
Speaker
(Model Varies)
Template Grille
EasyMount Bracket and Hardware
(anchors, screws, mounting posts, and knobs).
TriadSpeakers.com • Sales: 1800-666-6316
OnWall Speaker
- Product Info & Warranty - Page 1
Page 2
Triad OnWall Products w/ EasyMount Bracket - Quick Start Guide
2014.2.1
Vertical Installation
Horizontal Installation
Level & pin template to wall.
Outline wire hole and screw holes
for 2 mounting posts. Always orient
posts vertically.
Cut wire hole; install anchors if
there are no studs; screw 2 mounting
posts to wall. Mounting posts should
always be mounted vertically (portrait).
A
Pull speaker wire through wire
hole; attach to binding posts or
push connectors.
Mount speaker on posts; loosely
tighten knobs. Level or align +/- 1/4”
(6.35mm), then tighten.
Attach grille at one end; seat
edges along both sides; attach
other end. Snug all around.
C
B
D
E
On Stud
Off Stud
Off Stud
On Stud
OnWall Speaker - Installation Instructions - Page 2
Loading...