5 STEPS TO WORLD OF EFFECTS
Using your ToneBug Chorus + Flanger
Insert a 9V alkaline battery or connect to an electrical outlet using the
T-Rex Fuel Tank power supply (not included).
Plug your guitar into the INPUT jack, and run a lead from the OUTPUT
jack into your amp.
Use the Chorus/Flanger switch to choose which eect you want.
Use the RATE knob to set the speed of your modulation, and the
DEPTH knob to choose how “heavy” you want the chorused or
anged eect to be.
Then use the LEVEL knob to set your overall output volume – and go!
TECHNICAL SPECIFICATIONS:
Input Impedance @ 1KHz Higher than 1 M Ohm
Output Impedance @ 1KHz Lower than 1 K Ohm
Power supply 9V DC
Minimum Power supply Voltage 8V DC
Maximum Power supply Voltage 12,5V DC
Current Draw @ 9V DC 75 mA
Maximum input signal Vp/p 2,5 Vp/p
Battery Type 9V battery 6F22 Alkaline
Battery Life 0,5 to 1 Hours
External connectors Input Jack. Output Jack, 9V DC Jack (center
pin negative)
Controls On/O, Rate, Flanger, Depth, Chorus
Depth 120 mm
Width 78 mm
Height 60 mm
Weight (excl. battery) 0,404 Kg