TRENDnet TEW-453APB User Manual
TEW-453APB
Hot Spot Wireless Access Point
Quick Installation Guide
Point d'accès sans fil sensible
Guide d'installation rapide
Drahtloser Access Point für Hotspots
Kurzanleitung zur Installation
Guía de instalación rápida del
punto de acceso inalámbrico Hot Spot
Version 03.02.2005
TRENDnet
TRENDware, USA
What's Next in Networking
Copyright ©2005. All Rights Reserved. TRENDware International, Inc.
Table of Contents
English ......................................................................................................
1. Prepare for Installation ......................................................................
2. Install Hardware ................................................................................
3. Configure TCP/IP Settings ................................................................
4. Configure the Access Point ...............................................................
Troubleshooting...........................................................................................
1
1
2
3
9
11
English QIG
1. Prepare for Installation
Thank you for purchasing TRENDnet's TEW-453APB Hot Spot Wireless
Access Point.
This guide will help you set-up your Access Point quickly and easily. Just follow
the step-by-step instructions below, and enjoy the benefits of accessing the
Internet without ever being tied down to wires! If you run into problems, please
refer to the Troubleshooting section. If you need further technical support,
please visit www.TRENDNET.com or call technical support by phone.
Verify Package Contents
Please make sure you have everything in the box:
TEW-453APB
TEW-453APB
Hot Spot Wireless Access Point
Quick Installation Guide
Point d'accès sans fil sensible
Guide d'installation rapide
Drahtloser Access Point für Hotspots
Kurzanleitung zur Installation
Guía de instalación rápida del
punto de acceso inalámbrico Hot Spot
Version 03.02.2005
TRENDnet
TRENDware, USA
What's Next in Networking
Copyright ©2005. All Rights Reserved. TRENDware International, Inc.
Quick Installation Guide
CD-ROM
Power Adapter
(24V DC, 500mA)
Verify Equipment
Before setting up the Access Point, you should have the following:
1. A computer with Wired (RJ45) or Wireless network card.
2. TCP/IP protocol installed on the Computer.
3. A web browser such as Internet Explorer (5.0 or higher) or Netscape
Navigator (4.7 or higher).
4. A Hub or Switch connecting your existing wired network.
5. An RJ-45 Network Cable for connecting the Access Point to your network
switch.
1
English
2. Install Hardware
1. Locate an optimum location for the Access Point. The best place for the
Access Point is usually at the center of your wireless network.
2. Connect the RJ45 network cable to the Access Point, then connect the other
end of the network cable to a Switch or Hub. The Access Point is now
connected to your 10/100mbps network.
3. Connect the power adapter to the Access Point. Make sure you use the
power adapter supplied with the Access Point; using a different power
adapter may damage the unit.
TEW-453APB
3 22
NOTE: If you are using a wired computer to configure the Access Point,
please connect this computer to the same Switch or Hub the
TEW-453APB is connected to.
LAN
POWER
Verify Hardware Installation
Make sure the front panel lights are on: Power, LAN, Wireless.
2
Wireless
English
3. Configure TCP/IP Settings
Before the Access Point can be accessed and configured, the computer's
TCP/IP settings need to be changed.
Windows 98SE/ME
1. Find the Start button located on the Desktop.
2. Click Start, click Settings, and then click on Control Panel.
3. Double-Click the Network Icon, and the Network Properties box will
appear.
4. Under the Configuration tab, locate and select TCP/IP with the
corresponding network card. Then click on the Properties button and the
TCP/IP Properties window will appear.
3
English
Loading...