TRENDnet TEW-434APB User Manual
Quick Installation Guide
TEW-434APB
Table of Contents
Table of Contents
English ......................................................................................................
1. Before You Start
2. Hardware Installation .........................................................................
3. Power-over-Ethernet Installation ......................................................
4. Configure the Access Point ................................................................
Troubleshooting ........................................................................................
.................................................................................
1
1
2
3
5
8
Version 01.08.2007
1. Before You Start
Installation Requirements
Web Browser: Internet Explorer (5.5 or higher)
A computer with a network adapter properly installed
A network Switch or Hub with an available network LAN port
A RJ-45 network cable
Power over Ethernet Switch (Optional)
TPE-101I (Optional)
Application
54Mbps 802.11g Wireless
PoE Access Point
(TEW-434ABP)
Package Contents
TEW-434APB
Quick Installation Guide
User’s Guide CD-ROM
AC Power Adapter (7.5V 1A)
1 x 2dBi Detachable Antenna
Workstation with
Wireless PCI Adapter
(TEW-423PI)
Internet
Cable/DSL
Modem
100Mbps
PoE + Data
Power over Ethernet
(PoE) Injector
(TPE-101i)
Data
Cable/DSL 4-Port Firewall Router
(TW100-BRF114)
Notebook with
Wireless PC Card
(TEW-421PC)
Workstation with
PCI Adapter
(TE100-PCIWN)
Note: The TEW-434APB only support Power over Ethernet (PoE) devices that
follow the IEEE 802.3af Mode A (pin 1, 2, 3, 6) standard
1
English
2. Hardware Installation
Note: Locate an optimum location for the Access Point. The best place for the
Access Point is usually at the center of your wireless network. Please connect
the computer configuring the TEW-434APB to the same switch/hub.
1. Connect a RJ-45 cable from the
Switch/Hub to the LAN port of the
Access Point and then connect the
2dBi Detachable Antenna.
2. Connect the Power Adapter to the
Access Point and then to a power
outlet.
3. Verify that the following front panel
lights are on: WLAN and LAN.
2
English
Loading...