TRENDnet TEW-430APB User Manual

Quick Installation Guide

TEW-430APB

Table of Contents

Table of Contents

English ......................................................................................................

1. Before You Start

2. Install Hardware .................................................................................

3. Configure the Access Point ................................................................

Troubleshooting ........................................................................................

.................................................................................

1

1
2
3

6

Version 05.19.2006

1. Before You Start

Installation Requirements

Web Browser: Internet Explorer (5.5 or higher) or
Netscape Navigator (4.7 or higher).
A computer with a network adapter properly installed.
A network Switch or Hub with an available network LAN port.
A RJ-45 network cable.

Application

Package Content

TEW-430APB
Quick Installation Guide
User’s Guide CD-ROM
External Power Adapter
1 x 2dBi Detachable Antenna

54Mbps 802.11g Wireless LAN Access Point

(TEW-430APB)

Workstation with

Wireless PCI Adapter

(TEW-423PI)

Internet

Cable/DSL

Modem

Cable/DSL 4-Port

Firewall Router

(TW100-BRF114)

1

English

Notebook with

Wireless PC Card

(TEW-421PC)

Workstation with

PCI Adapter

(TE100-PCIWN)

2. Hardware Installation

Note: Locate an optimum location for the Access Point. The best place for the
Access Point is usually at the center of your wireless network. Please connect
the computer configuring the TEW-430APB to the same switch/hub.

1. Connect a RJ-45 cable from the
Switch/Hub to the LAN port of the
Access Point and then connect the
2dBi Detachable Antenna.

2. Connect the Power Adapter to the
Access Point and then to a power
outlet.

3. Verify that the following front panel
lights are on: WLAN and LAN.

2

English