Trendnet 15AH28B User Manual

Quick Installation Guide

15AH-28B

1. Before you start

Package Contents

15AH-28B
Quick Installation Guide
Wall Mount
Fasteners, washers and wall

mount screws

Installation Requirements

The following items below are not included. Users must provide the items
themselves. Make sure to have each item on hand before installation.

Internet Camera Server (e.g. TV-IP100, TV-IP201, TV-IP301)
Dry Wall or Wood surface
Power Cord
Knife or box cutter
Wire Stripper
Screwdriver
Pliers
Electrical Tape
RJ-45 cable
RJ-45 Jack

*Note: You must know how to terminate a network cable with an RJ-45 connector
in order to install a wired internet camera server into the 15AH-28B. If you do not
know how to terminate a network cable with an RJ-45 connector, please consult a
network professional.

1

English

Version 02.27.2007

2. Hardware Installation

Note: Configure your Internet Camera Server to match your network settings
before installing the device.

1. Lift up the latch and pull the roof
upward.

2. Remove the metal bracket from
the camera enclosure by
unscrewing the four screws. Save
these screws. You will need to use
these screws later.

3. Use the following 2 sets of screws
and washers to mount the metal
bracket onto the base of the
Internet Camera Server. The
screws and washers can be found
in the plastic bags included with
the 15AH-28B.

2

English

4. Flip over the camera housing and
remove the rubber stoppers and
washers.

5. Remove the circuit board from the
camera enclosure by unscrewing
the two screws. Save these
screws. You will need to use these
screws later.

6. Take a power cord and cut it using
a wire cutter. Cut it near the female
end of the power cord. Note: The
power cord is not included with
15AH-28B.

7. Cut the rubber insulation using a
knife or box cutter.

English

3

8. Remove the insulation with pliers.

9. Run the power cord through the

rubber stopper.

10. Insert the power cord through the
hole and securely screw in the
rubber stopper.

11. Insert the wires of the power cord

into the power receptacle. Make
sure the green and white wires
match up. Make sure the black
wires matches up with the orange
wires. Then use a screwdriver to
secure the wires.

4

English