Treasure Cove Fortune Finder 1020, TC-1023 Owner's Manual

Treasure Cove Metal Detector

Fortune Finder 1020

OWNER’S MANUAL

www.Treasure-Cove.com

805-658-2328

With your 1020 metal detector, you can hunt for coins, relics, jewelry, gold, and
silver just about anywhere, including lawns, snows, mountains and etc. The
detector is versatile and easy to use.
Four operating modes:
DISCRIMINATION --- in this mode, the unit comes with auto ground balance.
This mode can facilitate you to search for and discriminate the target type based
on the different tone for different metal target.

TONE---based on DISC/TONE control, the unit can discriminate the metal type
with high or low tone.

TARGET---to pinpoint the target accurately by lowering the sensitivity.

ALL METAL---to search for all kinds of metal object. In this mode, the unit comes

with auto ground balance.

· View Meter---in noisy area, you can search for metal object according to the
indication of view meter.

· Headphone Jack—lets you connect stereo headphones (not supplied) and
operate without trouble.

· Waterproof Searchcoil—lets you use the detector even if you must put it
under shallow water.

· Adjustable Stem---lets you adjust the detector’s length for comfortable use.

2

· Arm Support---lets you carry and operate your detector comfortably.

· Power---Your metal detector requires two 9-volt alkaline batteries (not supplied).

The built in insolating circuit can avoid wrong battery connection and prolong
the battery life.

PREPARATION

ASSEMBLING THE DETECTOR

Assembling your detector is easy and requires no special tools. Just follow these
steps:

1. Insert the latch on the liner into the assembly hole on the bottom of the control

box. Then slightly push the control box in the direction of IN on the handle to
fix the latch in place. Tighten the fixing screw properly.

liner

control box

fixing screw

latch

2. Unscrew the knobs on the search coil, then remove the knobs and the

connector. Insert the stem and align the holes on the search coil bracket and
the stem. Push the connector through the holes, then replace and tighten the
knobs.

3. Wind the search coil cable around the stem and insert its plug into the relevant

jack.

assembly hole

3