Page 1
Big Bore Shock Kit Instructions
Installation Note:
spacers, shock pistons, and upper shock bushings. The plastic shock bushings are required to be
used with the aluminum Big Bore shocks for smooth operation.
Fill the Shocks with Oil
Unscrew the shock cap from the top of the shock. Fill the shock with silicone shock oil up to the top
of the shock body. Slowly move the piston up and down (always keeping it submerged in oil) to
release the air bubbles. Let the shock sit for a few minutes to allow any remaining air bubbles to surface.
1. Remove the stock shocks. Retain all
hardware.
2. Install the lower Big Bore shock ends into
the desired shock location on the suspension
arms and secure the shocks with the retained
hardware. Note: Reuse of stock hollow ball
may be necessary in some applications.
3. Insert a plastic shock bushing (from the
included plastic parts tree) into each of
the Big Bore shock caps.
4. Insert a screw through each shock bushing
and secure each shock to the front and rear
shock towers.
If you have questions or need
technical assistance, call Traxxas at
The Big Bore Shock Kits come with two plastic parts trees with extra pre-load
Vehicle Front shock Rear shockVehicle
Bandit
Rustler
Stampede
Stampede 4x4
Slash
Slash 4x4
Long (2660)
Long (2660)
Long (2660)
Long (2660)
Long (2660)
Long (2660)
1-888-TRAXXAS
(1-888-872-9927) (U.S. residents only)
Traxxas, 1100 Klein Road, Plano, TX 75074,
T R A XXAS. c o m
Phone: 972-265-8000, Fax: 972-265-8011, e-mail: support@Traxxas.com
Covers Part #2658, #2659, #2660, #2661, #2662
2658 (short Big Bore shocks)
2659 (medium Big Bore shocks)
2660 (long Big Bore shocks)
2661 (X-long Big Bore shocks)
2662 (XX-long Big Bore shocks)
2362
XX-long (2662)
XX-long (2662)
XX-long (2662)
XX-long (2662)
XX-long (2662)
XX-long (2662)
2742X
2669
2362
2669
4261T (short)
4262T (medium)
1664T (long)
2765T (X-long)
2656T (XX-long)
Rev 130128-R00
2667
1765
2362
2663 (medium)
2664 (long)
2665 (X-long)
2666 (XX-long)
2668
2668
Loading...