Page 1
Wall Thermostat - Gas/Pellet Part # 99300650
CHECK CONDITION OF SHIPMENT
Upon receipt of this kit, check the condition of the packaging. Damage to the package should be noted on the carrier's freight
receipt. Any damage claims as a result of shipping must be handled through the shipper. Travis Industries will provide assistance
in resolving shipping claims or replacing items not included in the package. Please report any missing items immediately.
COMPATIBILITY
• All Travis Gas Stoves & Inserts • Newport (Avanti) Pellet Stoves & Inserts • Pioneer (Heritage Bay) Pellet Stoves & Inserts
ITEMS NEEDED FOR ASSEMBLY
• Standard Screwdriver • Additional tools may be required for laying the thermostat wire
• You may need additional tools to access the on/off switch on certain gas heaters - refer to the instructions in the owner's manual.
PACKING LIST
• Thermostat • Thermostat wire (25' long) • 2 Screws (for attaching the thermostat to wall)
INSTALLATION INSTRUCTIONS
! This kit must be installed by a qualified technician.
! Do not connect 110 VAC to the gas control valve or on/off switch on gas heaters or the thermostat posts on pellet heaters.
Gas Heater Installation
Remove the on/off wire on the lower post of the
a
on/off switch and attach it to the upper post.
Connect the thermostat wires to the lower two posts
b
on the on/off switch (orientation does not matter).
Red & brown wires
leading to the gas
control valve.
Pellet Heater Installation
Attach the thermostat wire to the
circuit board.
Back of on/off switch
Open the hopper lid and remove the
a
screw holding the right panel in place.
Phillips
Screwdriver
Swing the
panel
open.
Thread the thermostat wire, quickconnect end first, through the hole in the
b
rear panel.
d
c
Attach the quickconnects to the
thermostat posts
on the circuit
board (orientation
does not mater).
Pull on the thermostat
wire to allow just enough
slack to allow the right
side panel to open.
Page 1 of 2
10850 117th Place N.E. Kirkland, WA 98033
Printed February 3, 2003
Page 2
Wall Thermostat - Gas/Pellet Part # 99300650
Thermostat Placement and Installation
1 Determine a location for the thermostat that is within range of the 20' length of thermostat wire. It should be centralized in
the room and away from the heater. The wire may be routed externally on the wall or behind the wall (preferred). Run the
thermostat wire to this location. Use nylon ties, if necessary to keep the wire from contacting any hot portions of the heater.
2 Follow the directions below to attach the thermostat and thermostat wires.
Pull the cover off the thermostat
50 60 70 80 90
Robertshaw
50 60 70 80 90
Run the thermostat wires
through the wall (cut off excess
wire, leaving 6” of slack).
Expose 1/2” of wire and
attach to these two posts.
Standard
Screwdriver
Page 2 of 2
10850 117th Place N.E. Kirkland, WA 98033
Attach the thermostat to
the wall through these
two holes.
Printed February 3, 2003
Loading...