Page 1
Flush Wood Plus Face Installation Instructions
Rectangular Insert: Shadowbox Black 95600654, Shadowbox Bronze 95600657, Times Square 95600658
Facing
NOTE: Do not build facing (tile, brick) up to the faceplate. A gap is required to allow for air to circulate.
Packing List
Face Extension Rod(s)
Arched & Artisan use 1, all else use 2.
Sizing
Height
Width
907mm wide563mm high
Installation
1. Before installing the face, make sure
the insert is in place, attached to the
flue, and the surround panel is in place.
Remove the bypass and air control
rods (see “A” to the right).
2. Connect the rheostat wires and make
sure the power cord is routed through
the hole in the surround panel (see “B”
to the right).
Bypass Rod Handle
a
b
.cnI ,seirtsudnI sivarT © 51/8/6 detnirP - 05610671 2 fo 1 egaP
Page 2
Flush Wood Plus Face Installation Instructions
Rectangular Insert: Shadowbox Black 95600654, Shadowbox Bronze 95600657, Times Square 95600658
3. Attach the face as shown below (see “A” below).
4. Attach the air control and extender as shown below. Attach the bypass ring to the bypass rod, then to the
bypass extender, and install onto the bypass yoke.
WARNING: Make sure all wiring is inserted into the cavity between the insert and the fireplace.
Failure to do this may cause the wiring to become damaged.
a
b
HINT: While installing the bypass extension, reach into the firebox and hold the bypass
plate and yoke. See the manual for a detailed view.
.cnI ,seirtsudnI sivarT © 51/8/6 detnirP - 05610671 2 fo 2 egaP
Loading...