Transwest mk III Operating Instructions Manual

5 AMP POWER SUPPLY

F,,



Pk'

pot

<IDE

, • At:

OPERATING INSTRUCTIONS

POWER SUPPLY IS HIGHLY RECOMMENDED FOR:

*

SSB/AM/FM-UHF CB RADIO TRANSCEIVERS
* AMATEUR RADIO TRANSCEIVERS
*

CAR CASSETTE RADIO PLAYERS
*

INTRUDER ALARM SYSTEMS

*

BENCH POWER SUPPLY

WARNING:

DO NOT USE FOR
CHARGING CAR
BATTERIES.

SPECIFICATIONS (TYPICAL)

INPUT VOLTS



240V A.G. 50Hz

OUTPUT VOLTS



13.8 Volts ± 0.2 Volt
VOLTAGE REGULATION : Better than 2%
OUTPUT CURRENT



5 Amps Max at 50% Duty Cycle

RIPPLE & NOISE



: Less than 10 my RMS
SHORT CIRCUIT PROTECTED
S.E.C. APPROVAL



No. W/2014

OPERATION INSTRUCTIONS

Observe correct polarity red + (positive) terminal and black — (negative) terminal
when connecting to your power supply.

Do not exceed the maximum load rating of the power supply, otherwise the unit
may be damaged. 5 Amps @ 50% Duty Cycle e.g. 5 Amps @ 10 minutes on and

10 minutes off intervals. OVERLOADING YOUR POWER SUPPLY WILL

DAMAGE THE UNIT AND VOID THE WARRANTY.

Keep the power supply well ventilated. Do not obstruct ventilation holes by
placing articles on top of or against sides of the unit.

DO NOT use this unit for charging your car battery (it will overheat and be

damaged)
DO NOT remove the cover whilst the AC cord is plugged in.
DO NOT attempt to carry out any adjustments or modifications as this will

void your warranty.