Transtek Medical Electronics TMB1583 B User Manual
User Manual
version:1.0
Guangdong Transtek Medical Electronics Co., Ltd.
Zone A, No.105 ,Dongli Road, Torch Development District,
Zhongshan,528437,Guangdong,China
Blood Pressure Monitor
TMB-1583-BT
Arm Type
MEM
START
STOP
SET
Thank you very much for selecting TRANSTEK Blood Pressure Monitor
TMB-1583-BT.
Please do read the user manual carefully and thoroughtly so as to ensure
the safe usage of this product, and keep the manual well for further
reference in case you have problems.
CATALOGUE CATALOGUE
INTRODUCTION...................................................................................................................2
Table of Contents
General Description
Indications for Use
Safety Information
LCD Display Signal
Monitor Components
BEFORE YOU START...........................................................................................................8
The Choice of Power Supply
Installing and Replacing the Batteries
Measurement Principle
Setting Date, Time, Measurement Unit and Clock Mode
Select the User
Pair-up the Blood Pressure Monitor with Your Device
MEASUREMENT...................................................................................................................14
Tie the Cuff
Start the Measurement
DATA MANAGEMENT...........................................................................................................17
Recall the Records
Delete the Records
SPECIAL FUNCTION............................................................................................................19
About the Clock Mode
About the Lock Button
INFORMATION FOR USER..................................................................................................20
Tips for measurement
Maintenances
ABOUT BLOOD PRESSURE................................................................................................22
What are systolic pressure and diastolic pressure?
What is the standard blood pressure classification?
Why does my blood pressure fluctuate throughout the day?
Why do I get a different blood pressure at home compared to the hospital?
Is the result the same if measuring on the right arm?
TROUBLESHOOTING..........................................................................................................24
SPECIFICATIONS................................................................................................................25
AUTHORIZED COMPONENT .............................................................................................26
CONTACT INFORMATION...................................................................................................26
COMPLIED STANDARDS LIST............................................................................................27
FCC STATEMENT.................................................................................................................28
EMC GUIDANCE..................................................................................................................29
1
INTRODUCTION
INTRODUCTION
General Description
Thank you for selecting TRANSTEK arm type blood pressure Monitor
(TMB-1583-BT). The monitor features blood pressure measurement, pulse
rate measurement and the result storage. The design provides you with
two years of reliable service.
Readings taken by the TMB-1583-BT are equivalent to those obtained by
a trained observer using the cuff and stethoscope auscultation method.
This manual contains important safety and care information, and
provides step by step instructions for using the product.
Read the manual thoroughly before using the product.
Features:
84mm×73 mm Digital LCD display
Maximum 60 records
3rd technonoly: Measuring during inflation
(The updated technology in the world)
Indications for Use
The Transtek Blood Pressure Monitor is digital monitors intended for use in
measuring blood pressure and heartbeat rate with arm circumference ranging
from 22 cm to 32 cm ( about 8¾˝-12½˝ ) or 22cm to 42cm(about 8¾˝-16½˝).
It is intended for adult indoor use only.
Safety Information
The signs below might be in the user manual, labeling or other component.
They are the requirement of standard and using.
Symbol for “THE OPERATION
GUIDE MUST BE READ”
Symbol for “MANUFACTURER”
Symbol for “SERIAL NUMBER”
Symbol for “DIRECT CURRENT”
Symbol for “MANUFACTURE
DATE”
F1
T1A/250V Φ3.6*10CCC
The Bluetooth Combination Mark
Caution: These notes must be
observed to prevent any damage
to the device.
CAUTION
The device is not suitable for measuring the blood pressure of children. Ask your
doctor before using it on older children.
The device is not suitable for use on pregnant women, patients with implanted,
electrocical devices, patients with pre-elcampsia, premature ventricular beats, atrial
fibrillation, peripheral, arterial disease and patients undergoing intravascular therapy or
arterio-venous shunt or people who received a mastectomy. Please consult your
doctor prior to using the unit if you suffer from illnesses
Do not take any therapeutic measures on the basis of a self measurement. Never alter
the dose of a medicine prescribed by a doctor. Consult your doctor if you have any
question about your blood pressure.
Please keep the unit out of reach of infants, children or pets, since inhalation or
swallowing of small parts is dangerous or even fatal.
Symbol for “TYPE BF APPLIED
PARTS”
Symbol for “ENVIRONMENT
PROTECTION - Electrical waste
products should not be disposed of
with household waste. Please recycle
where facilities exist. Check with your
local authority or retailer for recycling
advice”
For indoor use only
Symbol for “Class II Equipment”
Symbol for “Including RF
transmitter”
2
3
INTRODUCTION
INTRODUCTION
CAUTION
This device is intended only for adult use in homes.
This device is intended for non-invasive measuring and monitoring of arterial blood pressure. It is
not intended for use on extremities other than arm or for functions other than obtaining a blood
pressure measurement.
If you experience discomfort during a measurement, such as pain in the arm or other complaints,
press the START/STOP button to release the air immediately from the cuff. Loosen the cuff and
remove it from your arm.
On the rare occasion of a fault causing the cuff to remain fully inflated during measurement, open
the cuff immediately. Prolonged high pressure (cuff pressure >300mmHg or constant pressure
>15mmHg for more than 3 minutes) applied to the arm may lead to an ecchymosis.
Too frequent and consecutive measurements could cause disturbances in blood circulation and
injuries.
Do not wrap the cuff on the same arm which other monitoring ME EQUIPMENT is applied
simultaneously, because this could cause temporary loss of function of those simultaneously-used
monitoring ME EQUIPMENT.
Don’t kink the connection tube during use, otherwise, the cuff pressure may continuously increase
which can prevent blood flow and result in harmful injury to the PATIENT.
The maximum temperature that the applied part can be achieved is 42.5℃ while the environmental
temperature is 40℃.(only for wrist blood pressure monitor)
The equipment is not AP/APG equipment and not suitable for use in the presence of a flammable
anesthetic mixture with air of with oxygen or nitrous oxide.
This unit is not suitable for continuous monitoring during medical emergencies or operations.
This device cannot be used with HF surgical equipment at the same time.
This device is not intended for patient transports outside a healthcare facility.
To avoid measurement errors, please avoid the condition of strong electromagnetic field radiated
interference signal or electrical fast transient/burst signal.
The operator shall not touch output of batteries/adapter and the patient simultaneously.
Manufacturer will make available on request circuit diagrams, component parts list etc.
The materials of the cuff have been tested and found to comply with requirements of ISO
10993-5:2009 and ISO 10993-10:2010. It will not cause any potential sensization or irritation
reaction.Never apply the cuff over hurt skin.
Do not use the unit in case of existing polyester resp. synthetic allergies.
Be careful to strangulation due to cables and hoses, particularly due to excessive length.
Do not connect the air hose to other medical equipment, as this could cause air to be pumped into
intravascular systems or high pressure, what could lead to dangerous injuries.
Before use, make sure the device functions safely and is in proper working condition.
Please use the device under the environment which was provided in the user manual. Otherwise,
the performance and lifetime of the device will been impacted and reduced.
Please use ACCESSORIES and detachable partes specified/ authorised by MANUFACTURE.
Otherwise, it may cause damage to the unit or danger to the user/patients.
Please dispose of ACCESSORIES, detachable parts, and the ME EQUIPMENT according to the
local guidelines.
Please do not attempt to repair the unit yourself in the event of malfunctions. Only have repairs
carried out by authorized service centers.
Please report to Manufacturer if any unexpected operation or events occur.
The device doesn’t need to be calibrated in two years of reliable service.
Please use the soft cloth to clean the whole unit. Don’t use any abrasive or volatile cleaners.
4
LCD display signal
SYMBOL DESCRIPTION
Systolic blood pressure High pressure result
Diastolic blood pressure Low pressure result
Pulse per minute Beats per minute, BPM
Average value
Memory
kPa
mmHg
Low battery
Irregular heartbeat
Grade
Current Time
EXPLANATION
The average value of the latest three
records
The displayed measurement values
is from the memory.
Measurement Unit of the blood pressure
(1kPa=7.5mmHg)
Measurement Unit of the blood pressure
(1mmHg=0.133kPa)
Batteries are low and need to be replaced
Irregular heartbeat Detection
The grade of the blood pressure
Year/Month/Day(M/D or D/M),
Hour/Minute
5
SYMBOL DESCRIPTION EXPLANATION
ErrorError
Hour The hour in the clock mode
Minute
Second
Heartbeat
User 1
User 2
Bluetooth icon
The minute in the clock mode
The second in the clock mode
Heartbeat detection during the
measurement
Start measurement,save and transmit the
measuring results for User 1
Start measurement,save and transmit the
measuring results for User 2
The bluetooth icon blinks when the
bluetooth is working
Monitor Components
LCD DISPLAY
AIR HOSE
MEM
MEM BUTTON
START/STOP BUTTON
Component list of
pressure measuring system
1 Cuff
2 Air pipe
3 PCBA
4 Pump
5 Valve
LOCK BUTTON
START
STOP
SET
BATTERY COMPARTMENT
INTRODUCTIONINTRODUCTION
CUFF
SET BUTTON
List
1.Blood Pressure Monitor
(TMB-1583-BT)
MEM
START
STOP
SET
3. 4×AAA alkaline batteries
6
2.Cuff (Type BF applied part)
(22cm~32cm or 22cm~42cm)
4.User manual
DC POWER SOCKET
(Please use TRANSTEK
authorized cuff. The size
of the actual cuff please
refer to the label on the
attached cuff.)
5. AC Adaptor
(KH0601000UW !)
AIR CONNECTOR PLUG
7
Loading...