Transition Networks CFETF1011-200, CFETF1013-200, CFETF1014-200, CFETF1015-200, CFETF1016-200 User Manual

COMPLIANCE INFORMATION

UL Listed
C-UL Listed (Canada)
CISPR/EN55022 Class A & B

FCC Regulations

This equipment has been tested and found to comply with the limits for a class A & B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at the user’s own expense.

Canadian Regulations

This digital apparatus does not exceed the Class A & B limits for radio noise for digital apparatus set out
on the radio interference regulations of the Canadian Department of Communications.

Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables
aux appareils numériques de la class A & B prescrites dans le Règlement sur le brouillage radioélectrique
édicté par le ministère des Communications du Canada.

European Regulations

Warning

This is a Class A & B product. In a domestic environment this product may cause radio interference in
which case the user may be required to take adequate measures.

Achtung !

Dieses ist ein Gerät der Funkstörgrenzwertklasse A & B. In Wohnbereichen können bei Betrieb dieses
Gerätes Rundfunkstörungen auftreten, in weichen Fällen der Benutzer für entsprechende
Gegenmaßnahmen werantwortlich ist.

Attention !

Ceci est un produit de Classe A & B. Dans un environment domestique, ce produit risque de créer des
interférences radioélectriques, il appartiendra alors à l’utilsateur de prende les measures spécifiques
appropriées

Trademark Notice

All registered trademarks and trademarks are the property of their respective owners.

Copyright Restrictions

© 2000, 2001 TRANSITION Networks.
All rights reserved. No part of this work may be reproduced or used in any form or by any means –
graphic, electronic, or mechanical – without written permission from TRANSITION Networks.

Printed in the U.S.A. 33171.C

CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE
PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in
damage to the public telephone network.

Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-Mitgliedstaaten
verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur
Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen
einschliesslich der gegenseitigen Anerkennung ihrer Konformität.

TRANSITION Networks CFETF10xx series Fast Ethernet™media converters,

designed to be installed in a PointSystem

™

Conversion Center

™

, connect

100BASE-TX shielded or unshielded
twisted-pair copper cable to 100BASE-FX

multimode or singlemode fiber-optic

cable.

*In CFETF10xx model designation, 10
represents the100BASE-TX RJ-45 connector;
xx represents the selectable fiber connector
installed on the media converter.

100BASE-TX to 100BASE-FX

Slide-In-Module Media Converters

CFETF10xx*-200

USER’S GUIDE

CFETF1011-200

Provides an RJ-45 twisted-pair copper
100BASE-TX connector and a set of RX
(receive) and TX (transmit) ST 100BASE-FX
connectors to multimode 1300 nm fiber­optic cable.

CFETF1013-200

Provides an RJ-45 twisted-pair copper
100BASE-TX connector and an RX
(receive) and TX (transmit) MM-SC
100BASE-FX connector to multimode
1300 nm fiber-optic cable.

CFETF1014-200

Provides an RJ-45 twisted-pair copper
100BASE-TX connector and an RX
(receive) and TX (transmit) SC 100BASE-FX
connector to singlemode 1300 nm fiber­optic cable.

CFETF1015-200

Provides an RJ-45 twisted-pair copper
100BASE-TX connector and an RX
(receive) and TX (transmit) SC 100BASE-FX
connector to singlemode 1300 nm fiber­optic cable.

CFETF1016-200

Provides an RJ-45 twisted-pair copper
100BASE-TX connector and an RX
(receive) and TX (transmit) SC 100BASE-FX
connector to singlemode 1300 nm fiber­optic cable.

CFETF1017-200

Provides an RJ-45 twisted-pair copper
100BASE-TX connector and an RX
(receive) and TX (transmit) SC 100BASE-FX
connector to singlemode 1550 nm fiber­optic cable.

CFETF1018-200

Provides an RJ-45 twisted-pair copper
100BASE-TX connector and an RX
(receive) and TX (transmit) MT-RJ
100BASE-FX connector to multimode
1300 nm fiber-optic cable.

10BASE-T

INPORT

MCCM10

MGMT MASTER

RX

TX

LNK

PWR

OUTPORT

RESET

DB-9

12C

12C-1TERM

INIT

CFMFF100

10BASE-2

CECF100

CFMFF100

0

50

‰

CFMFF100

CETTF100

Link

Alert

E

D

CETCF100

CFETF110

CFMFF100

CFMFF100

LKS

PWR

LKM

LKS

PWR

LKM

Multimode

Singlemode

TX

RX

TX

RX

LKF

PWR

RXF

RXC

LKC

LA

PWR

RXF

RXC

LNK

COL

SPD

PWR

FRX

CRX

FLNK

CLNK

RX

TX

10/100TX

RX

TX

10/100SX

CFETF100

SPD

PWR

FRX

CRX

FLNK

CLNK

RX

TX

100BASE-FX

Link

Alert

E

D

0

50

‰

Multimode

Singlemode

TX

RX

TX

RX

LA

PWR

RXF

RXC

LNK

COL

LKS

PWR

LKM

10BASE-2

10BASE-FL

10BASE-T

LKS

PWR

LKM

LKS

PWR

LKM

Multimode

Singlemode

TX

RX

TX

RX

Multimode

Singlemode

TX

RX

TX

RX

Multimode

Singlemode

TX

RX

TX

RX

10BASE-T

10BASE-FL

Media
Conversion
Center

Power

In Use

1

Power

In Use

2

CFETF10xx in the Network . . . . . . . . .2

Installation . . . . . . . . . . . . . . . . . . . .5

Operation . . . . . . . . . . . . . . . . . . . . .6

Fault Isolation and Correction . . . . .8

Cable Specifications . . . . . . . . . . . . .9

Technical Specifications . . . . . . . . .11

Compliance Information . . . . . . . . .12

CFETF10xx IN THE NETWORK

The CFETF10xx receives and transmits network signals in either full­duplex or half-duplex mode, depending upon the network devices to
which the media converter is attached and upon the Auto-negotiation
switch setting. (See page 4 for switch setting description.)

Fast Ethernet

™

in full-duplex mode allows the maximum cable distances

shown in the cable specifications on page 10. Fast Ethernet

™

in half-

duplex mode requires attention to the 512-bit Rule. (See page 3.)

Network Configurations

Install two CFETF10xx series media converters in series to extend, over
fiber, the distance between two 100BASE-TX devices:

Alternatively, use one CFETF10xx media converter to connect a
100BASE-TX terminal device and a 100BASE-FX hub, switch, or router.

Or use one CFETF10xx media converter to connect a 100BASE-TX hub,
switch, or router and a 100BASE-FX terminal device.

TECHNICAL SPECIFICATIONS

Standards IEEE 802.3 1998
Data Rate 100 Mb/s

Dimensions 3.4" x 0.86" x 5.0" (86mm x 22mm x 127mm)
Weight 8 oz (approximate)
Power Consumption 3.4 watts
Environment Typical Operating Temperature*: 0-50°C (32°to 122°F )

Storage Temperature: -20 to 85°C
Humidity 10-90%, non condensing
Altitude 0-10,000 feet

Warranty Lifetime
*Operating temperature range for this Slide-In-Module depends on the physical

characteristics and the installation configuration of the TRANSITION Networks
chassis in which this Slide-In-Module will be installed. See the User’s Guide for
the chassis in which this Slide-In-Module will be installed for a discussion of
temperature-related installation constraints.

DECLARATION OF CONFORMITY

Name of Mfg: Transition Networks

6475 City West Parkway, Minneapolis MN 55344 USA
Model: CFETF10xx-200 Series Media Converters
Part Number(s): CFETF1011-200, CFETF1012-200, CFETF1013-200, CFETF1014-200,

CFETF1015-200, CFETF1016-200, CFETF1017-200, CFETF1018-200

Regulation: EMC Directive 89/336/EEC
Purpose: To declare that the CFETF10xx-200to which this declaration refers is

in conformity with the following standards.

EMC-CISPR 22: 1985 Class A&B; EN 55022:1988 Class A&B; EN 50082-1:1992;
EN 60950 A & B4:1997; IEC 801.2, IEC 801.3, and IEC 801.4; IEC 950

I, the undersigned, hereby declare that the equipment specified above conforms to the
above Directive(s) and Standard(s).

_March 16, 2001_____

Stephen Anderson, Vice-President of Engineering Date

10BASE-T

INPORT

MCCM10

MGMT MASTER

RX

TX

LNK

PWR

OUTPORT

RESET

DB-9

12C

12C-1TERM

INIT

CETTF100

CFETF110

LKF

PWR

RXF

RXC

LKC

SPD

PWR

FRX

CRX

FLNK

CLNK

RX

TX

10/100TX

RX

TX

10/100SX

CFETF100

SPD

PWR

FRX

CRX

FLNK

CLNK

RX

TX

100BASE-FX

10BASE-T

10BASE-FL

Media
Conversion
Center

Power

In Use

1

Power

In Use

2

PWR

LKC

SPD

FRX

CRX

10/100TX

RX

TX

10/100SX

SPD

PWR

FRX

CRX

FLNK

CLNK

RX

TX
100BASE-FX

10BASE-T

INPORT

MCCM10

MGMT MASTER

RX

TX

LNK

PWR

OUTPORT

RESET

DB-9

12C

12C-1TERM

INIT

CETTF100

CFETF110

LKF

PWR

RXF

RXC

LKC

SPD

PWR

FRX

CRX

FLNK

CLNK

RX

TX

10/100TX

RX

TX

10/100SX

CFETF100

SPD

PWR

FRX

CRX

FLNK

CLNK

RX

TX
100BASE-FX

10BASE-T

10BASE-FL

Media
Conversion
Center

Power

In Use

1

Power

In Use

2

PWR

LKC

SPD

FRX

CRX

10/100TX

RX

TX

10/100SX

SPD

PWR

FRX

CRX

FLNK

CLNK

RX

TX
100BASE-FX