FLOOR LAMP
Assembly Instructions
CAUTION
• Inspect the wire insulation for any cuts,
abrasions, or exposed copper that may have
resulted during shipping. If there is a defect in
the wire, do not attempt installation.
TOOLS REQUIRED
• Before starting installation of this fixture or
removal of a previous fixture, disconnect the
power by turning o the circuit breaker or by
removing the fuse at the fuse box.
Ladder
Safety
glasses
Electrical
tape
Phillips
screwdriver
screwdriver
PliersFlat blade
Harp
Wire
strippers
Fixture
Shade
Finial
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
page 1
FLOOR LAMP
Assembly Instructions
STEP 1
Assemble the fixture by screwing the parts
together until it is secure taking care not to over
tighten or to tangle or twist the branch wires.
Attach the harp into the fixture. Place the shade
on top and complete the assembly with the finial.
Install a bulb (not included).
As you assemble the light fixture, pull the power cable
from the base to eliminate any excess cable length
that may occur.
page 2
Loading...