TransCore 05946 User Manual

PocketPass™

Installation Instructions

16-0042-001 Rev A2

PocketPass is designed for mounting to a vehicle's interior windshield surface using 3M™
Dual Lock™ strips. This mounting method provide for easy mounting and removal when
portability is needed.

General Installation Information

Metallized Windshields

Some vehicle windshields contain a metallic treatment that could prevent an interior windshield-mounted
device from working correctly. If you have a vehicle with a metalized windshield, contact your local
customer service center for more information. If your vehicle’s metalized windshield has a metal-free
zone, it is typically located near the rearview mirror.

Required Supplies

• PocketPass

• Commercial glass cleaner and paper towels

PocketPass Installation and Removal Procedures

Installing the PocketPass with Dual Lock Strips

1. Choose the location for your PocketPass (Figure 1). It should be mounted as close to the bottom
center of the windshield as possible; at least 3 inches away from the windshield frame or
dashboard, and not behind the windshield wipers.

Figure 1 –

Trusted Transportation Solutions

Installation Instructions

2. Clean and dry the interior windshield surface completely before axing the Dual Lock strips. The
windshield temperature must be at least 68ºF (20ºC) for optimum bonding.

3. Peel the backing o the Dual Lock strips (Figure 2). Leave both sides of the Dual Lock strips
pressed together to ensure the strips will align between the tag and windshield. Apply the
PocketPass to the windshield using moderate pressure.

Figure 2 –

Note: When installing the PocketPass using Dual Lock strips for the first time, leave it in
place for at least 24 hours to allow the adhesive to cure.

4. To remove a PocketPass mounted with Dual Lock strips from the windshield, grip the case at the
top and bottom sides. Gently lift the PocketPass away from the windshield on one end until the
tag is free from the windshield.

User Replaceable Batteries

Two AAA batteries are pre-installed in your PocketPass. TransCore recommends Energizer® Advanced
Lithium AAA batteries for use in the PocketPass.

To replace the batteries, remove the tag from the windshield as described in Step 4 on page 2.

1. Hold the tag with the LED side facing down. Locate the battery door. Press the indentation
located under the arrow and slide the door in the direction of the arrow to open the door.

Page 2