Page 1
HOMESTEAD
TFB52Q
ASSEMBLY GUIDE
Please read this entire manual before installation and use of this pellet fuel-burning appliance. Failure to follow these instructions could result in property
damage, bodily injury, or even death. Contact your local building or fire ocials about restrictions and installation inspection requirements in your area.
A MAJOR CAUSE OF FIRES IS FAILURE TO MAINTAIN REQUIRED CLEARANCES (AIR SPACES)
BETWEEN COMBUSTIBLE MATERIALS. IT IS OF UTMOST IMPORTANCE THAT THIS PRODUCT BE
INSTALLED ONLY IN ACCORDANCE WITH THESE INSTRUCTIONS. SAVE THESE INSTRUCTIONS.
WARNING!
MANY PARTS OF THE GRILL WILL BECOME VERY HOT DURING OPERATION. CARE MUST BE TAKEN TO AVOID BURNS,
BOTH DURING OPERATION AND AFTERWARDS, WHILE THE GRILL IS STILL HOT.
TRAEGER PELLET GRILLS LLC
1215 E. WILMINGTON AVE
SALT LAKE CITY, UT 84106
TRAEGERGRILLS.COM
TFB52QCE/QSE/QPE/QZE
Never leave the grill unattended when young children are present.
Never move the grill when it is operating.
Let the grill cool completely before moving or attempting to transport.
Page 2
PARTS LIST
BLISTER PACK PARTS NEEDED
16
(Hopper grate
inside hopper)
10
5
9
A
Bolts: 5/16-18x2.5 (6 pcs)
11
12
B
Washers: 5/16 (16 pcs)
8
C
Spring Washers: 5/16 (8 pcs)
6
Hex Nuts: 5/16-18 (8 pcs)
D
7
14
Probe 1
Probe
Selector
Probe 2
13
E
Bolts: 5/16-18x3.5 (2 pcs)
F
Washers: 1/4 (6 pcs)
3
15
1
G
Handle Insulation (2 pcs)
4
2
WARNING!
• When operating this grill under overhead combustibles, a MINIMUM
of 40 inches (102 cm) is required.
• When operating this grill, maintain a MINIMUM distance of 18 inches
(45.7 cm) from the grill to combustibles.
IMPORTANT!
• The grill is very heavy. Always lif the grill with TWO people.
18.00"
(45.7 cm)
40.00"
(102 cm)
18.00"
(45.7 cm)
Bolts: 1/4-20x.75 Phillips (4 pcs)
H
I
Hex Nuts: 1/4-20 (2 pcs)
J
Shoulder Bolts: 1/4-20 (4 pcs)
Wrench (1 pc)
Screwdriver (1 pc)
Hex Key (1 pc)
Temperature
CALL
SERVICE
F
275
225
325
180
375Smoke
Shut Down
High
Cycle
OFF
Power
ON
6-Pack
GRAB THE 6-PACK, GET THE TOOLS, CUE THE RADIO —
IT’S ALMOST TRAEGER’ING TIME.
Optional Equipment:
Page 3
READ ALL INSTRUCTIONS BEFORE INSTALLING AND USING THE GRILL
Traeger’ing is more fun with friends! (No, really, you will need two people to lif the grill.)
NOTE: You should assemble grill on a clean, flat surface, as you will need to lay
it on its back as well as its front at dierent times during assembly.
1
UNBOX GRILL AND
REMOVE CONTENTS
Probe 1
Probe 2
Probe
Selector
2
INSTALL LEGS
2A
Grill is very heavy. Always lif grill
with two people.
NOTE: To protect the finish of the
grill, use the plastic bag covering the
grill as a barrier between grill and
cardboard when assembling the legs.
2B
In this step:
x 4 B x8 C x 4 D x 4 From Side: E x 2 B x 4 C x 2 D x 2
A
1 2
NOTE: When fastening legs to grill body, fasteners
assemble in this order:
2C
In this step: 3 4
From Front/Rear: A x 2 B x 4 C x 2 D x 2
or E B Leg B C D
A
Page 4
Probe
Selector
Probe 1
Probe 2
3
ATTACH HANDLE AND CHIMNEY ASSEMBLY
THIS WILL REQUIRE TWO PEOPLE.
3A
4
ATTACH FRONT SHELF ASSEMBLY
4A 4B
3B
In this step:
x 2 G x 2 F x 2
5 H
3C
In this step: 6 7 8 H x 2 F x 4 I x 2
5
PLACE INTERIOR PARTS
AND HANG BUCKET
5A
In this step: 13 + 1/4-20 x 4,
repeat on other side.
NOTE: Bolts installed in grill body.
5
(continued)
5B
In this step:
11
YOU ARE READY TO SEASON YOUR GRILL AND GET TRAEGER’ING!
Refer to your Owner’s Manual for operation instructions.
In this step:
repeat on other side.
5C
In this step: 9 10
J x 4,
14
In this step: 12
5D
In this step: 15
Loading...