Trade Mark GTH 1056 User Manual
HIGH REACH ROUGH TERRAIN TELEHANDLER
GTHTM-1056
Specifications
MODEL GTHTM-1056
MEASUREMENTS US Metric
Maximum lift height 56 ft 10 in 17.32 m
Reach 42 ft 12.80 m
A
Height, stowed 8 ft 6 in 2.59 m
B
Length, stowed (without forks) 21 ft 6.40 m
Width 8 ft 6 in 2.59 m
C
Wheelbase 10 ft 8 in 3.25 m
Ground clearance, center 1 ft 10 in 0.56 m
D
Ground clearance, axle 1 ft 6 in 0.46 m
E
Fork cross section 2.25 x 4 in 57 x 101 mm
PRODUCTIVITY
Maximum lift capacity 10,000 lbs 4,536 kg
Lift capacity at maximum height 4,000 lbs 1,814 kg
Lift capacity at maximum reach 3,000 lbs 1,361 kg
Raise/Lower boom 13/12 sec
Extend/Retract 16/15 sec
Frame leveling 10° side to side
Drive speed 17 mph 27 km/h
Draw bar pull 28,800 lbs 13,063 kg
Turning radius, outside (4WS) 13 ft 3 in 4.04 m
Auxiliary hydraulic flow 2-15 gpm 8-57 lpm
Auxiliary hydraulic pressure 3,200 psi 220 bar
Tires, standard size 14 x 24 in, 12 ply
POWER
Power source Perkins 1104D-E44TA 4 cylinder diesel,
John Deere 4045HF48 5 4 cylinder diesel,
125 hp (93.2 kW)
Electrical system System voltage 12 volt
Alternator 95 amp
Battery 1000 CCA at 0˚F (-18˚C)
Hydraulic tank capacity 44 gal 167 L
Hydraulic system capacity (w/tank) 55 gal 208 L
Fuel tank capacity 35 gal 132 L
WEIGHT
Weight* 30,000 lbs 13,608 kg
STANDARDS COMPLIANCE ANSI/ ITSDF B56.6, CSA B335
123 hp (95 kW)
D
C
B
LOAD CHART GTHTM-1056**
60 ft
18.29 m
50 ft
15.24 m
40 ft
12.19 m
30 ft
9.14 m
20 ft
6.1 m
10 ft
3.05 m
0 ft
0 m
-10 ft
3.05 m
50 ft 40 ft 30 ft 20 ft 10 ft 0 ft -10 ft -20 ft
15.24 m 12.19 m 9.14 m 6.1 m 3.05 m 0 m -3.05 m -6.1 m
30˚
20˚
10˚
0˚
3000 lbs/1,361 kg3000 lbs/1,361 kg
-7˚
50˚
40˚
,814 kg
1
4,000 lbs/
4,000 lbs/1,814 kg
6,000 lbs/2,722 kg
6,000 lbs/2,722 kg
With stabilizers down
60 ft
18.29 m
50 ft
15.24 m
40 ft
12.19 m
30 ft
9.14 m
20 ft
6.1 m
70˚
60˚
,000 lbs/4,536 kg
0
8,000 lbs/3,629 kg
8,000 lbs/3,629 kg
1
10,000 lbs/4,536 kg
A
E
* Weight will vary depending on options and/or country standards.
** Load ratings vary depending on attachment.
www.genieindustries.com
10 ft
3.05 m
0 ft
0 m
-6 ft
-1.83 m
50 ft 40 ft 30 ft 20 ft 10 ft 0 ft -10 ft -20 ft
15.24 m 12.19 m 9.14 m 6.1 m 3.05 m 0 m -3.05 m -6.1 m
00 lbs/136 kg
3
00 lbs/907 kg
2,0
1,000 lbs/454 kg
3,500 lbs/1,588 kg
5,000 lbs/2,268 kg
10 ,000 lbs/4,536 kg
,000 lbs/2,722 kg
8,000 lbs/3,629 kg
6
With stabilizers up
HIGH REACH ROUGH TERRAIN TELEHANDLER
Features
STANDARD FEATURES OPTIONS & ACCESSORIES
GTHTM-1056
MEASUREMENTS
• 10,000 lb (4,536 kg) maximum lift
capacity
• 56 ft 10 in (17.32 m) maximum lift height
• 42 ft (12.80 m) maximum reach
PRODUCTIVITY
• Full time planetary 4-wheel drive
• 4WS
• Operator selectable front, crab,
coordinated steering modes
• Frame leveling 10° side to side
• 3-speed forward and reverse
powershift transmission
• Power assisted steering
• Inboard wet disc service brakes
• Wet disc spring applied parking brake
• 14 x 24 in 12-ply, air filled, all terrain tires
• Front axle differential lock
• Rear axle stabilization system
• Twin axle mounted stabilizers
• High efficiency/variable displacement
hydraulic pump
• ROPS/FOPS canopy (ISO compliant)
• Single, multi-function, proportional
joystick
• Machine level indicator
• Full instrumentation
• 48 in carriage and pallet forks
• Boom angle indicator
• Retractable 3 in (8 cm) seatbelt
• Left front and rear tire fenders
• Reverse motion alarm
PRODUCTIVITY
• Fully enclosed cab (includes full glass,
defroster, wiper, washer, right-side
sliding window, split door)
• Fully enclosed cab with air conditioning
• Right-side sliding window
• Glass over skylight bars
• Front window
• Front screen
• Right-side screen
• Adjustable suspension seat
• Dual joystick controls
• Flashing beacon
• Work lights (2 cab mounted front,
1 back-up, 1 stop/tail, illuminated
dash gauges)
• Road lights (2 cab mounted front,
1 back-up, 2 rear stop/turn/tail,
2 front turn, illuminated
dash gauges)
• Auxiliary hydraulic circuit
• Fenders (full set)
• Mounted disposable fire extinguisher
ATTACHMENT OPTIONS
• Carriages- Quick Attach
- 72 in (1.83 m) swing carriage
(45° from center left and right)
- 48 in (1.22 m) rotating carriage
(10° from center left and right)
- 60 in (1.52 m) rotating carriage
(10° from center left and right)
- 72 in (1.83 m) rotating carriage
(10° from center left and right)
• Carriages: Quick Attach or Pin On
- 60 in (1.52 m) wide fork carriage
- 72 in (1.83 m) wide fork carriage
• Forks (in addition to standard
48 in pallet forks)
- 60 in (1.52 m) pallet forks (set of two)
2.25 x 4 x 60 in (.06 x .10 x 1.52 m)
- 72 in (1.83 m) pallet forks (set of two)
2.25 x 4 x 72 in (.06 x .10 x 1.83 m)
- 60 in (1.52 m) full taper forks (set of
two) 2.25 x 5 x 60 in (.06 x .13 x 1.52 m)
- 60 in (1.52 m) lumber forks (set of
two) 1.75 x 7 x 60 in (.04 x .18 x 1.52 m)
- Cubing tines (set of 6)
• Bucket
- Light duty rubbish bucket -
1 yd
3
(0.76 m3)
• 14 ft variable reach truss boom
ENGINE OPTIONS
• John Deere 125 hp
turbo-charged diesel engine
• Perkins 123 hp turbo-charged diesel
engine
• Electric ether aid for John Deere only
• Electric block heater for Perkins
TIRE OPTIONS
• 14 x 24 in 12-ply foam-filled all terrain tires
• 14 x 24 in 12-ply foam-filled rock lug tires
• 14 x 24 in 12-ply air-filled rock lug tires
Genie United States
18340 NE 76th Street
P.O. Box 97030
Redmond, Washington 98073-9730
Telephone +1 (425) 881-1800
Toll Free in USA/Canada +1 (800)-536-1800
Fax +1 (425) 883-3475
Effective Date: January, 2010. Product specifications and prices are subject to change without notice or obligation. The photographs and/or drawings in this document are for illustrative purposes only. Refer to the appropriate Operator’s
Manual for instructions on the proper use of this equipment. Failure to follow the appropriate Operator’s Manual when using our equipment or to otherwise act irresponsibly may result in serious injury or death. The only warranty applicable
to our equipment is the standard written warranty applicable to the particular product and sale and we make no other warranty, express or implied. Products and services listed may be trademarks, service marks or trade-names of Terex
Corporation, Genie Industries, Inc. and/or their subsidiaries in the U.S.A. and many other countries and all rights are reserved. Terex
Registered Trademark of Genie Industries, Inc. in the U.S.A. and many other countries. Genie is a Terex Brand. © 2010 Terex Corporation.
GTH1056 0210K. Part No. 109423
Genie Europe
The Maltings
Wharf Road
Grantham NG31 6BH
UK
Telephone +44 (0)1476 584333
Fax +44 (0)1476 584334
Email: AWP-InfoEurope@terex.com
®
is a Registered Trademark of Terex Corporation in the U.S.A. and many other countries. Genie® is a
Distributed By:
www.genieindustries.com
Loading...