Trac Vac 380, 385-LH, 385-IC Operating And Assembly Manual

2-0916

Model 380/385-IC/385-LH

Operating and Assembly

Manual

Midwest Equipment Manufacturing, Inc.

5225 Serum Plant Road

Thorntown, IN 46071

1

CAUTION!!!!
SPINNING BLADE

SAFETY RULES

Remember, any power equipment can cause injury if operated improperly or if the user does not understand

how to operate the equipment. Exercise caution at all times when using power equipment.

This symbol means Attention!!!!! It is used to point out safety precautions.

▪ Read and follow all instructions in this manual before assembly or operation of this equipment.
Failure to comply with these instructions may result in personal injury. Keep this manual for
future reference and for ordering replacement parts.
▪ Read this instruction manual carefully. Become familiar with the controls and proper use of this
equipment.
▪ Read the engine owners manual and safe operation rules before using this equipment.
▪ Never allow children less than 16 years of age to operate the Trac-Vac. Children 16 years
and older should operate only under close parental supervision.
▪ Do not allow anyone to operate this equipment without proper instruction.
▪ Do not allow passengers to ride on the Trac-Vac or on the towing vehicle.
▪ Keep children and pets out of area of operation.
▪ Check fuel before starting engine. Do Not fill fuel tank indoors, or while engine is running or
hot. Wipe off any spilled fuel before starting engine.
▪ Engine and muffler get HOT! Do Not touch! Keep debris from accumulating on or around
engine and muffler to avoid fire hazard.
▪ Allow engine to cool before storing in any enclosed area. Never store Trac-Vac with fuel in tank.
▪ Do not operate engine if air cleaner or cover is removed, except for adjustments. Removal of the
part could create a fire hazard.

▪ Keep hands, feet, face, long hair and clothing out of inlet and discharge areas. There are

ROTATING BLADES inside these openings.

▪ Make certain that all moving parts come to a complete stop before cleaning, repairing or
inspection. Disconnect spark plug wire and keep away from plug to prevent accidental starting.

▪ If Trac-Vac should become clogged with debris, SHUT OFF ALL ENGINES and wait until
impeller comes to a complete stop before attempting to remove obstruction. Disconnect spark
plug wire to prevent accidental starting.
▪ If excessive vibration occurs while operating your Trac-Vac, stop the engine immediately,
disconnect the spark plug wire and allow all moving parts to stop completely before taking the
following steps.
A. Inspect for damage.
B. Repair or replace any damaged parts.
C. Check for loose parts and tighten to assure continued safe operation.
▪ Check all hardware periodically to insure safe operation.
▪ Check cart cover periodically for wear and replace if worn or damaged.
▪ Never operate Trac-Vac without intake hose and exhaust hose attached in proper place.
▪ Do Not remove exhaust hose or attempt to empty contents of container while engine in running.
▪ Keep all shields and guards in place and securely attached.
▪ Always wear eye protection (safety glasses or goggles) when operating this equipment.
▪ Do Not stand behind unit in exhaust discharge area while engine is running.
▪ Do Not operate this equipment while intoxicated or while taking medications that could impair
reactions or senses.
▪ Operate this equipment at reduced ground speed on rough terrain, along creeks and ditches and on
slopes to prevent tipping or loss of control.
▪ Vehicle stability and braking are affected by the addition of this unit. Do not fill the Trac-Vac to
its full capacity without checking the capability of the towing vehicle to safely pull and stop with
the unit attached.
▪ Do Not operate on slopes in excess of 10 degrees. STAY OFF OF STEEP SLOPES!
▪ Follow the maintenance instructions outlined in this manual.

2

Model 380/385 Trac-Vac Parts List

Key Part No. Description Qty.

1 38010 Engine Frame, RH 1
38011 Engine Frame, LH (385-LH) 1
2 38012 Container Frame 1
3 38015 Vertical Upright 1
4 38020 Engine, 3.5 HP B&S (380-) 1
56021 Engine, 5.5 HP B&S Intek IC (385-) 1
56018 Engine, 6.5 HP B&S Intek Pro 1
56017 Engine, 6.5 HP Intec Pro Elec. St. 1
5 56030 Turbine Housing, 6" 1
6 56040 Turbine, 5HP 1
7 56107 Turbine Washer 1
8 56050 Inlet, 6" 1
9 68050 Wheel, Pneumatic 2
10 46233 Filter Support 1
11 46217 Top Support 1
12 56115 Nylon Spacer 3
13 47222 Molded Top 1
14 46228 Filter 1
15 46219 Seal, Molded Top 1
16 46235 Container Latch 1
17 48040 Intake Nozzle 1
18 3120518 Eyebolt 2
19 48038 Spring 2
20 46218 Clevis Pin, Vertical Support 1
21 46210 Container, 44 Gallon 1
22 56102 Hose Clamp, 6" 4
23 46103 Exhaust Hose-HD, 6" x 36" 1
24 48050 Intake Hose, 6" x 80" 1
25 48047 Support Arm 1
26 58072 Hose Support Strap, 6" 1
27 58104 Hitch Pin 1
28 46248 Filter Shield 1
29 38018 Support Arm Bracket 1
30 47411 2" Sq. Bend U-Bolt 1
31 2510108 Turbine Bolt (3.5 HP Briggs) 1

3120608 Turbine Bolt (5.5 HP Briggs Intek) 1
32 3120612 Housing Bolt 4
33 3750238 Turbine Set Screw 1
34 1871714 Turbine Key 1
35 86115 Exhaust Deflector (5.5HP Briggs only) 1
36 2500801 Turbine Lock Washer (3.5 HP Briggs only) 1
37 ***-6 6" Deck Chute Ass'y (Deck Specific) 1
38 58075 Engine Guard 1
45131 Decal, 2" x 8", Trac-Vac, White
45133 Decal, Warning Stop Engine
48096 Decal, Danger Stop Engine
18110 Key Switch (Elec. Only)
56122 Spacer Kit (Elec. St. Only)

Optional Accessories:

Key Part No. Description

39 150 4” Remote Pickup Assembly

160 6” Remote Pickup Assembly
40 48066 Tow Kit