Industrial Power Supplies TBLC Series, 6 – 90 W
CB
• Low profile case, module depth only
59,5mm
• Suitable for mounting in domestic
installation panels
• Low output ripples and spikes
• Fully compliance to ECO-Standard
• Suitable for houshold appliance
• Safety class ll product
• UL 1310 class II, NEC class 2
compliance
• UL 508 listed
• Universal input range 85 to 264 VAC
• Operating temperature range:
–25°C to +70°C max.
Scheme
UL60950-1
UL508
UL1310
• Adjustable output voltage
Short circuit and overload protection
• DC–OK indicator
This new DIN-Rail mounting power supplies are designed for industrial and resi-
dential applications. They are lower cost than the existing TBL range, with similar
electrical specifications. Additionally, they fully comply to the new standby power
and efficiency requirements (ECO Standard). They are intended for connect-
ing as class II devices, so the safety earth connection is not required. They are
mountable in flat racks due to their small dimensions in depth. Their dimensions
comply to the DIN 43 880 standard.
Models
Order Code Output Power
(max.)
TBLC 06-105 6 W
TBLC 06-112 6 W
TBLC 06-124 6 W
TBLC 15-105 12 W
TBLC 15-112 15 W
TBLC 15-124 15 W
TBLC 25-105 20 W
TBLC 25-112 24 W
TBLC 25-124 25 W
TBLC 50-112 48 W
TBLC 50-124 50 W
TBLC 75-112 72 W
TBLC 75-124 75 W
TBLC 90-112 90 W
TBLC 90-124 90 W
Output Voltage*
(nom.)(adjustable)
5.0 VDC 1.2 A 74 %
12 VDC 0.5 A 81 %
24 VDC 0.25 A 79 %
5.0 VDC 2.4 A 81 %
12 VDC 1.25 A 85 %
24 VDC 0.63 A 85 %
5.0 VDC 4.0 A 82 %
12 VDC 2.0 A 86 %
24 VDC 1.05 A 87 %
12 VDC 4.0 A 88 %
24 VDC 2.1 A 89 %
12 VDC 6.0 A 89 %
24 VDC 3.1 A 89 %
12 VDC 7.5 A 90 %
24 VDC 3.75 A 90 %
Output Current
(max.)
Efficiency
(typ.)
http://www.tracopower.com Page 1 of 5
TBLC Series, 6 – 90 W
Input Specifications
Input voltage – nominal ranges 100 – 240 VAC; 50/60 Hz
– effective ranges 85 – 264 VAC; 47-63 Hz
(below 100 VAC a derating of 2%/V is required)
Input voltage frequency 47 – 63 Hz
No load power consumption 6–50 W models: > 0.3 W
75–90 W models: > 0.5 W
Harmonic limits EN 61000-3-2, class A
Leakage current 0.25 mA max.
Inrush current 6–50 W models: 15/30 A (115 / 2 3 0 V A C )
75–90 W models: 25/50 A (115 / 2 3 0 VA C )
Output Specifications
Output voltage / current 5 VDC models: 5.0 – 5.5 VDC*
12 VDC models: 12.0 – 16.0 VDC*
24 VDC models: 24.0 – 28.0 VDC*
Regulation – Input variation 0.3 % max.
– Load variation (10–90 %) 0.3 % max.
Hold-up time 60 ms min. (at 230 VAC)
15 ms typ. (at 115 VAC)
Start-up – Start up behaviour TBLC 075-112 and 090-112: 0-75 % constant current load
other models: 0-100 % constant current load
– Start up time 1 s max.
Ripple and Noise (20MHz bandwidth) 50 mVp-p max.
Current limit (continuous) 105 – 130 % of Iout nom., constant current
Short circuit current 70 – 200 % of Iout nom. (typ.), foldback
Output overvoltage protection 150 % of Vout nom. (typ.)
DC OK signal – trigger threshold ON > 95 % of the set voltage
General Specifications
Operating temperature –25°C to +70°C max.
derating above +55ºC : 2.5%/K
Storage temperature –40°C to +85°C max.
Temperature coefficient 0.02 %/K
Cooling convection cooling, no internal fan
Pollution degree 2
Humidity (non condensing) 5–95 % rel. H max.
Altitude during operation 4800 m max.
Isolation – I/O isolation 3000 VAC (4242 VDC )
Class of protection safety class II
Degree of protection IP 20 (IEC/EN 60529)
* Output voltage can be adjusted as indicated. However, output power has to be maintained at nominal value. This means the output
nominal current has to be reduced in accordance with the increase of output voltage.
All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
http://www.tracopower.com Page 2 of 5
TBLC Series, 6 – 90 W
General Specifications (continued)
Safety standards – Information technology equipment
– Household applications IEC/EN 60335-1
– Safety of machinery EN 60204
– Safety for power electronic conver ter systems IEC /EN 62477
– Industrial control equipment UL 508
– Class II Power units UL 1310
– NEC class 2 UL 1310 (except TBLC 75-112 and 90-112)
– Electronic equipment for power installation E N 5 0178
– Safety of transformers EN 61558-2-8, EN 61558-2-16
– Certification documents (pending) www.tracopower.com/overview/tblc
Electromagnetic compatibility (EMC), Emissions EN 61000-6-3, EN 61204-3
– Conducted RI suppression on input EN 55022 class B,
– Radiated RI suppression EN 55022 class B,
– Harmonic current emissions IEC 61000-3-2 class A
Electromagnetic compatibility (EMC), Immunity EN 61000-6-2, EN 61204-3
– Electrostatic discharge (ESD) IEC/EN 61000-4-2 4 kV/8 kV criteria B
– Radiated RF field immunity IEC/EN 61000-4-3 10 V/m criteria A
– Electrical fast transient / burst immunity IEC/EN 61000-4-4 2 kV criteria B
– Surge immunity IEC/EN 61000-4-5 1 kV/2 kV criteria B
– Immunity to conducted RF disturbances IEC/EN 61000-4-6 10 V criteria A
– Power frequency field immunity IEC/EN 61000-4-8 30 A/m criteria A
– Mains voltage dips and interruptions IEC/EN 61000-4-11
0% / 20ms
40% / 200ms
70% / 500ms
Environment – Vibration acc. IEC 60068-2-6 3 axis, 2g sine sweep, 10 – 55 Hz, 11 Oct/min
– Shock acc. IEC 60068-2-27 3 axis, 20g half sine, 11 ms
Enclosure material V2 rated plastic
Mounting – DIN-rail mounting for DIN-rails as per EN 50022-3515/7.5
(snap-on with self-locking spring) (included)
Environmental compliance – Reach www.tracopower.com/products/reach-declaration.pdf
– RoHS RoHS directive 2011/65/EU
Connection screw terminal with combi-type screwheads
for wire size 0.5 – 2.5mm
IEC/EN 60950-1, UL 60950-1
2
http://www.tracopower.com Page 3 of 5
TBLC Series, 6 – 90 W
V
I short
I max
I nominal
Function Specification
Block Diagram
Current Limit Characteristic
> 70% Inominal
The load characteristic is designed to accomplish reliable start-up of devices requiring full current at reduced output DC voltage.
The maximum current will not exceed 200% of the nominal or 8A, whilst the output power will always be less than 100W for normal and overload operation with nominal output voltages (except TBLC 90-112).
Note: All 6W models (TBLC 06-xxx) implement a pulsing power characteristic when in overload or short circuit conditions
< 200% Inominal
All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
http://www.tracopower.com Page 4 of 5
www.tracopower. com
TBLC Series, 6 – 90 W
Outline Dimensions
59.5 mm
Model Width (A)
mm
TBLC 006
TBLC 015
TBLC 025
TBLC 050
TBLC 075
TBLC 090
18 60
27 80
36 110
54 180
72 220
90 280
Weigth
g (oz)
45 mm
43.5 mm
54.5 mm
A
89.5 mm
Wiring
AC Input
DC Output
DC Output
Wall Mounting Bracket
Instead of on a DIN-rail, the modules can also be mounted on a chassis or wall with help of a
mounting bracket which is supplied as standard with each power supply
Dimensions in [mm], () = Inch
Description Wire size Torque
all models: L, N only (2 pin terminal) AWG 20 – 14 / 0.5 – 2.5 mm² max. 0.5 Nm
6 – 50 W models: single terminal AWG 20 – 14 / 0.5 – 2.5 mm² max. 0.5 Nm
75 – 90 W models: double terminal AWG 20 – 14 / 0.5 – 2.5 mm² max. 0.5 Nm
Tolerances: ±0.5 mm (±0.02)
© Copyright 2016 Traco Electronic AG Specifications can be changed without notice!
Rev. March 0 6. 2017
Page 5 of 5
Loading...