Trackunit TU50X-1 SPOT Installation Manual

Spot installation guide
Placement instructions
Vertical installation
Ensure that antenna is not facing the floor. Use sticker on the backside as indicator of the bottom side.
Horizontal installation
Be aware that antenna is placed on the top right corner. Use sticker on the backside for reference
.
Practical advice
Serial number is located on the back of the GPS/(GSM/UMTS) unit.
GSM number and
unit
serial number is also located on the lid of the box.
Mount Trackunit Spot using M4 or 5/32 inch screws wi t h minimum length of 2 inches
Do NOT install the GPS/(GSM/UMTS) unit directly under a layer of metal or next
t
wires
o
Spot installation guide
Handling recommendations
Approvals
Use location
This equipment design applies to commercial or industrial equipment expected to be installed in locations where only adults are normally present
CE mark
The TU50X-1 SPOT product complies with the essential requirements of the RED Directive 2014/53/EU directive with respect to the EMC requirements, safety and radio spectrum matters.
Environmental
The TU50X-
1 SPOT
product complies
environmental
conditions for heavy
trucks SAE J1455 with
the
IP66K and IP69K
classification as shown
in the list below.
Life time
The expected product
operational lifetime is
between 6 month to 5
years dependent on
the actual tracking
profile applied.
Operating temperature
The TU501-X SPOT operating temperature
range is
primary cell Lithium metal (Li-MnO2/Li-SOCl2)
batteries
pack is safety compliant to IEC 60086-4.
Battery pack
The battery pack can be exchanged when the unit run out of power. Contact the Trackunit support for acquiring a new battery pack and instruction on how to change it.
the
FCC/IC
The TU50X-1 SPOT product contains radio transmitters that comply with CFR 47 Part 15, Part 22 and Part 24 of the FCC rules and with RSS-GEN, RSS­132, RSS-133 and ICES­003 of Industry Canada requirements
-40°C to +70°C (Non-rechargeable
in the battery pack). The battery
Loading...
+ 2 hidden pages