TRACKMATE GPS MINI PRO 3G Installation Manuals

WELCOME!

Welcome to a new dimension of safety and security for your
vehicles with your purchase of the TrackmateGPS MINI PRO 3G.
It operates on the combined AT&T/T-Mobile networks, which
assures to have excellent coverage in the US. You are now able
to have control of your vehicles, whether you operate a
business with company cars, a fleet of limousines, or you are a
parent of a teenage driver. The MINI PRO 3G lets you know
where your car is at alltimes. In addition to all the basic tracking
features, it records potentially dangerous driver behavior, such
as harsh braking and sudden acceleration. It can even signal you
if someone exceeds your pre-determined speed limit or enters
an area you you’d rather him/her not be there.

The MINI PRO 3G is ideal for commercial or personal use, simple
to install and easy to use.

*Read this Registration / Installation Guide carefully before
installing your new MINI PRO 3G.

STEP ONE: Registration and Activation

Before you turn on or install your MINI PRO 3G, you must create
an account, and register your device(s) on our website. At the
account setup page, you will be prompted to fill out the account
information form. Next you will be prompted to select one of
the service plans: saver, basic, premium or platinum. After
selecting a service plan you will be prompted to enter your
credit card information.

You will now be redirected to the homepage where you will be
able to enter the device’s serial number which can be found on
the device.

STEP TWO: Installation

Estimated time required for installation: 30 to 45 minutes for
experienced installer – 1 to 2 hours for novice.

 It is recommended you use a professional car electrician to

install your tracker. However, if you're handy, you may
choose to install it on your own. Tools needed for
installation: voltage tester/meter, wire stripper, electrical
tape, wire connectors, fuse taps (optional)

 The tracker should be connected to a power source

providing 10V-30V DC. The wiring must be connected to
constant power for correct tracking. The power
consumption is minimal (<30mA), and should not affect
your vehicle battery, unless the vehicle is not used for an
extended period (several weeks)or the vehicle battery is in
poor condition.

 Connect both provided antennas. The antennas have

either male or female connectors. Attach to correct
connector.

 The wiring harness has twelve wires(approximately 2.5ft

long). For basic tracking features, just three of these wires
are utilized.Connect the wiring harness to the device.Strip
the black, red and orange wires. Ground the black wire
securely. The red wire should be connected to a constant
power source (fuse or wire) providing between 8V and
32V. Finally, the orange wire has to be connected to
ignition/accessory or any fuse/wire which is powered by