TRACKMATE GPS DASH T9 Registration / Installation Manual

1

2

Table of Contents

WELCOME! ...................................................... 3

STEP ONE: Registration and Activation

.... 3

STEP TWO: Installation ................................... 4

FREE TRIAL PERIOD ......................................... 9

OTHER IMPORTANT INFORMATION ............. 10

THANK YOU! .................................................. 11

3

WELCOME!

Welcome to a new dimension of safety and security for your
vehicles with your purchase of the TrackmateGPS DASH T9 and
its advanced technology. You are now able to have control of
your vehicles, whether you operate a business with company
cars, a fleet of limousines, or you are a parent of a teenage
driver. The DASH T9 lets you know where your car is at all times.
It can even signal you if someone exceeds your pre-determined
speed limit or enters an area where you prefer the driver not
be.

The DASH T9 is ideal for commercial or personal use, simple to
install and easy to use.

*Read this Registration / Installation Guide carefully before
installing your new DASH T9.

STEP ONE: Registration and Activation

Before installing your DASH T9 you must have an account to
register your device(s) on trackmategps.com. If you don’t
already have an account, you can create one on our website.

1. At the account setup page, you will be prompted to

fill out the account information form.

2. Next you will be prompted to select one of the

service plans:

a. Basic
b. Premium
c. Platinum

4

3. After selecting a service plan, you will be prompted

to enter your credit card information.

4. You will now be redirected to the homepage where

you will be able to enter the device’s serial or IMEI
number which can be found on the device and on
the box.

5. Any subsequent devices may be registered by

navigating to the “Register Device” page located
under the “Devices” section of the website menu.

STEP TWO: Installation

Estimated time required for installation: 30 to 45 minutes for
experienced installer – 1 to 2 hours for novice.

▪ It is recommended that you use a professional

car electrician to install your tracker. However,
if you are familiar with auto electronics, you
may choose to install it on your own.
Tools needed for installation:

o Voltage tester/meter
o Wire stripper
o Electrical Tape
o Wire connectors
o Fuse taps (optional)