Tracer AM07014 User Manual

INSTALLATION
Lamp-Ballasted Models (Ceiling Mount)

• Select a location within 2 feet (0.6 m) of an electrical outlet.

• Using the 6-foot (1.8 m) chain provided, suspend the lamp

assembly from a suitable ceiling mount.

Self-Ballasted Models (Ceiling or Wall Mount)

• Select a location within 2 feet (0.6 m) of an electrical outlet.

• Remove the reel from the bracket assembly by depressing

the release button on bracket Aand sliding bracket B out of
the way.

• Secure bracket Ato a stud or joist using the #12 screws
supplied. Use all 3 screws to ensure security of the bracket.

• Place the reel in bracket A. Insert bracket B into bracket A
until a click is heard. The reel is now securely locked in the
bracket.

OPERATION

• Connect the primary cord to a power outlet that complies
with the electrical requirements listed on the lamp. See the
operating instructions enclosed with the lamp for full
information.

• Pull the cord out to the desired length and stop. If the cord

does not hold, continue to pull the cord slowly, stopping
every 4 inches (10 cm). This will engage the lock. To
retract, pull the cord out 2 to 4 inches (5 to 10 cm) and guide
the cord slowly back into the reel.

• Do not pull hard on the cord when it is fully extended to

35 feet (10.7 m). This will cause malfunction of the

retracting spring.

• Do not allow the cord to fly unrestricted back into the
reel.

MAINTENANCE

• Remove dirt and grime as soon as it accumulates on the reel
case. Wipe clean with a dampened cloth. Do not use
solvents such as gasoline, turpentine, etc., to clean the
unit.

• Keep the cord clean to ensure the smoothest automatic

retraction. Pull the cord to its full length and allow it to
retract through a clean, dampened cloth. Pull out the full
length again and allow it to retract through a clean, dry cloth

sprinkled with talcum powder.

GENERAL SAFETY INFORMATION

• This unit should be used indoors. Do not use near potentially

dangerous locations such as flammable or explosive
atmospheres or near water.

• Use only 3-wire extension cords that have 3-prong grounding
plugs and 3-pole receptacles that accept the unit’s plug.

• Disconnect the unit from the power supply before servicing
or inspecting it for any reason.

CORD REEL

35 Foot (10.7 m), Retractable

Lamp-Ballasted Models

Self-Ballasted Models

A

Release
Button

B

6/07 AM07014
PRINTED IN U.S.A.