TQL TQ LT1203 User Manual

CONNECT ING

1. This set applies to AC 100V-240V, 50/60Hz

2. AC power: battery can be charged when connected to AC power.
Red light on battery is charging, it will change to green once bat-

IMPORTANT SAFE TY MEASU RES

TQ-LT1 203 / TQ-LT12 04

Before usi ng th is ma chi ne, p lea se read all the safety and operatin g ins tru cti ons ,
meanwhil e, pl eas e obs erv e all the indications about safe op era tin g. These s afe ty an d
operatin g ins tru cti ons s hou ld be kept in condition of consulta tio n.

tery complete charge.

3. Internal battery will be charged even device switch off when plu­ gged in to AC power

4. Speaker battery can be charged using 12V external car battery

as well(connect cable not included) by "DC 12V input". Please
make sure "+" and "-" in right connection.

5. Adjust function keys to your personal audio preference.

USER MANUAL

BATTERY & CHARGING

1. The units takes approximately 8 hours to fully charge. It will
automatically begin charging once the power cord is connected.

2. If the battery power is low may caused sound distortion or stop
play, please charging the battery on time.

3. To maximize the battery's lifespan, please charging the battery

210mm 210mm

immediately. When the unit is not used for prolonged periods of
time,the battery will gradually lose its power. It is recommended
to fully charge the battery at least every 30days.

4. To saving battery, please power off once stop using.

TQ-LT1 203 TQ-LT12 04

1. Protect ion o f ele ctr ic po wer s upply line: Be aware that the elect ric p owe r sup ply l ine i s not
tramped, p res sed b y hea vy ob jects. Pay special attention to the pl ug of p owe r sup ply l ine a nd outlet
on the machi ne. D O NOT lengthe n the e lec tri c sho ck, D O NOT p ull o r dra g or th e pow er supply line.

2. Ventilat ion : This set must be put i n ven til ate d pla ce. DO NOT pu t disk on it or cloth to cover it. The
distance a way f rom t he wa ll sh ould not be less than 10 centimeters. DO N OT put this set on the bed,
sofa, carp et or o the r obj ect s wit h similar surface in case of good ven til ati on.

3. Casing Di sma ntl ing : DO NO T dis man tle t he ca sin g . If one touches the inner components, h e wil l
probably g et se rio us el ect ric shock.

4. Unusual s mel l: Wh en yo u dis cover unusual smell and smoke, cu t pow er su ppl ies i mmediately and
pulls out th e plu s fro m the o utl et on t he wall. Contact the sell shop or nea res t rep air ing c enter.

Attentio n: This set applies to AC 110V~240V / 50Hz~60 Hz po wer s upp ly. Us e sta nda rd po wer s upply.
Please be su re fo r te co rre ct po wer s upply before use it.

TQ-LT1 502 / TQ-LT15 03

PRODUCT F EATURES

●Wireless

●Plays Mp3 files stored in SDC card/USBC drive/external audio
device.

●FM radi o ●Gui tar i nput ●Microphone in put s

●Wirel ess m icr ophone includ ed ●Wi th re mot e control

●Built -in r echargeable batt ery ●S upe r dynamic sound spea ker

REAR PANEL FUNCTIO N INSTRUC TION

RE MOTE C ONT ROL

Sta ndby

USB C/SDC /LINE ( Audio i nput)

Pre v/FM CH -

TQ-LT1 502 TQ-LT15 03

PROFESSIONAL SPEAKER

PLEASE READ TH IS USER M ANUAL CAREFULLY BEFORE SYSTEM CONNECT

MADE IN CHINA

148.5mm 148.5mm

148.5mm 148.5mm

Pla y/pau se/FM t uner

Nex t/FM CH +

Rep eat

Sto p

Volu me up

Volu me down

Mut e

Equ alize r

Num ber

WIRELES S INSTRUC TION

Change the mode into “BLUC”, the wireless sign light twinkles, and
speaker have sound “di”. Set on mobile phone, connect to wireless
data, search equipment and match properly. The proper connect
wireless lights keep on, and music work on speaker normally.

FCC STATEMENT

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.

2. Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/ TV technician for help.