Specifications are subject to change without notice.
trademark of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are
trademarks or registered trademarks of their respective holders.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that
may cause undesired operation.
FCC Radiation Exposure Statement
This device has been tested for compliance with FCC RF Exposure (SAR) limits in the
typical laptop computer configuration and this device can be used in desktop or laptop
computers with side mounted PCMCIA slots. This device cannot be used with handheld
PDAs (personal digital assistants). This device and its antenna must not be co-located or
operated in conjunction with any other antenna or transmitter.
CE Mark Warning
This is a class B product. In a domestic environment, this product may cause radio
interference, in which case the user may be required to take adequate measures.
Appendix C: Contact Information ....................................................................................22
TL-WN310G 54M Wireless Adapter User Guide
Package Contents
The following contents should be found in your box:
¾ One TL-WN310G Wireless Adapter
¾ Quick Installation Guide
¾ One Resource CD for TL-WN310G, including:
• TP-LINK Wireless Client Utility (TWCU) and Drivers
• User Guide
• Other Helpful Information
Note: If any of the listed contents are damaged or missing, please contact the retailer
from whom you purchased the TL-WN310G Wireless Adapter for assistance.
- 1 -
TL-WN310G 54M Wireless Adapter User Guide
Chapter1. Introduction
1.1 Overview of the product
The TP-LINK 54M Wireless Adapter TL-WN310G gives you the flexibility to install your PC
or notebook PC in the most convenient location available, without the cost of running
network cables.
The adapter's auto-sensing capability allows high packet transfer rate of up to 54Mbps for
maximum throughput, or dynamic range shifting to lower speeds due to distance or
operating limitations in an environment with a lot of electromagnetic interference. It can
also interoperate with all 11Mbps wireless (802.11b) products. Your wireless
communications are protected by up to 152-bit WEP and WP A encryption for high security.
1.2 Features
¾ Complies with IEEE 802.11g, IEEE 802.11b standards
¾ Supports WPA/WPA2 data security, IEEE 802.1x authentication, TKIP/AES
encryption, 64/128/152-bit WEP encryption
¾Supports 54/48/36/24/18/12/9/6Mbps or 11/5.5/2/1Mbps wireless LAN data transfer
rates
¾ Provides 32-bit CardBus interface
¾ Supports Ad-Hoc and Infrastructure modes
¾ Supports roaming between access points when configured in Infrastructure mode
¾ Ease to configure and provides monitoring information
¾ Supports Windows 2000, XP
¾ Internal Antenna
1.3 LED Status
LED
Indications
Status Green Not lit
Activity Green Lit
Status Green Lit
Activity Green Intermittently
Status Green Lit
Activity Green Flashing
TL-WN310G Working Status
Disable Radio
The adapter is trying to scan a networking
connection.
The adapter is transmitting or receiving data.
- 2 -
TL-WN310G 54M Wireless Adapter User Guide
Chapter2. Installation Guide
2.1 Hardware Installation
To install the adapter, follow these steps listed below:
1. Locate an available CardBus slot on your laptop.
2. With the connector pin end facing the CardBus slot and the label facing up, slide the
Adapter into the CardBus slot until it locks in place.
3. The Status LED should Intermittent flashing when the Adapter is installed correctly.
2.2 Software Installation
2.2.1 Overview
The Adapter’s Setup Wizard will guide you through the Installation procedure for Windows
2000, XP. The Setup Wizard will install the TP-LINK Wireless Client Utility (TWCU) and
drivers.
When you install the hardware before installing the software, the system will prompt
“Found New Hardware Wizard”, click Cancel, and run the Setup Wizard program on the
CD-ROM.
The Setup steps for Windows 2000, XP are very similar. The following setup steps are for
Windows 2000.
2.2.2 Software Installation for Windows 2000
1. Insert the Resource CD into your CD-ROM drive, Click the St art button and choose
Run. In the field that appears, enter F:\XXX\Setup.exe (If "F" is the letter of your
CD-ROM drive, XXX represents the setup program path, which is labeled on the
Resource CD), then Figure 2-1 will appear.
Figure 2-1
2. You can click Cancel to end the installation in the screen above. Otherwise, the
- 3 -
TL-WN310G 54M Wireless Adapter User Guide
installation will continue, and then Figure 2-2 will display after a moment.
Figure 2-2
3. To continue the installation, click Next in the screen abov e ( shown in Figu re 2- 2) , and
then you will see the next screen (shown in Figure 2-3). To end the Installation, click
Cancel.
Figure 2-3
4. In the screen above (shown in Figure 2-3), you should choose a Setup type. It is
recommended that you select Install Client Utilities and Driver. Select Install Driver Only to install driver only, select Make Driver Installation Diskette(s) to
make the diskette(s) as the installation driver. After selecting, click Next to continue
the Installation, and then the next screen will appear (shown in Figure 2-4). You may
click Back to return to the previous screen, or click Cancel to end the Installation.
- 4 -
TL-WN310G 54M Wireless Adapter User Guide
Figure 2-4
5. In the screen above, click Browse to change the destination location for the software.
After that, click Next, and you will see the next screen (shown in Figure 2-5), or click
Back to return to the previous screen, or click Cancel to end the Installation.
Figure 2-5
6. In the screen above (shown in Figure 2-5), you should create a new folder name or
select one from the Existing Folders list. It is recommended that you keep the
default setting. Click Next, and then you will see the next screen (shown in Figure
2-6). Click Back to return to the previous page, or click Cancel to end the Installation.
- 5 -
Loading...
+ 17 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.