Specifications are subject to change without notice. is
a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other
brands and product names are trademarks or registered trademarks of their
respective holders.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
responsible for compliance could void the user’s authority to operate the
equipment.
Note: The manufacturer is not responsible for any radio or tv interference
caused by unauthorized modifications to this equipment. Such modifications
could void the user’s authority to operate the equipment.
FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for
an uncontrolled environment. This device and its antenna must not be colocated or operating in conjunction with any other antenna or transmitter.
“To comply with FCC RF exposure compliance requirements, this grant is
applicable to only Mobile Configurations. The antennas used for this
transmitter must be installed to provide a separation distance of at least 20
cm from all persons and must not be co-located or operating in conjunction
with any other antenna or transmitter.”
CE Mark Warning
● Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including
interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party
This is a class B product. In a domestic environment, this product may cause
radio interference, in which case the user may be required to take adequate
measures.
Canadian Compliance Statement
This device complies with Industry Canada license-exempt RSSs.
Operation is subject to the following two conditions:
1) This device may not cause interference, and
2) This device must accept any interference, including interference that
may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes :
1) l'appareil nedoit pas produire de brouillage, et
2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
Industry Canada Statement
Complies with the Canadian ICES-003 Class B specifications.
Cet appareil numérique de la classe B est conforme à la norme NMB-003
du Canada.
CAN ICES-3 (B)/NMB-3(B)
Cet équipement est conforme aux limites d'exposition aux rayonnements IC
établies pour un environnement non contrôlé. Cet équipement doit être
installé et utilisé avec un minimum de 20 cm de distance entre la source de
rayonnement et votre corps.
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body.
Déclaration d'exposition aux radiations:
減少電磁波影響,請妥適使用。
安全諮詢及注意事項
● 請使用原裝電源供應器或只能按照本產品注明的電源類型使用本產品。
● 清潔本產品之前請先拔掉電源線。請勿使用液體、噴霧清潔劑或濕布進行
清潔。
AT
BG
BY
CA
CZ
DE
DK
EE
RU
SE
SK
TR
UA
US
● 注意防潮,請勿將水或其他液體潑灑到本產品上。
● 插槽與開口供通風使用,以確保本產品的操作可靠並防止過熱,請勿堵塞
或覆蓋開口。
● 請勿將本產品置放於靠近熱源的地方。除非有正常的通風,否則不可放在
密閉位置中。
● 請不要私自打開機殼,不要嘗試自行維修本產品,請由授權的專業人士進
行此項工作。
Продукт сертифіковано згідно с правилами системи УкрСЕПРО на
відповідність вимогам нормативних документів та вимогам, що
передбачені чинними законодавчими актами України.
Safety Information
service, please contact us.
● Avoid water and wet locations.
This product can be used in the following countries:
ES FI FR GB GR HU IE IT
LT LV MT NL NO PL PT RO
● When product has power button, the power button is one of the way to
shut off the product; when there is no power button, the only way to
completely shut off power is to disconnect the product or the power
adapter from the power source.
● Don’t disassemble the product, or make repairs yourself. You run the
risk of electric shock and voiding the limited warranty. If you need
TP-LINK TECHNOLOGIES CO., LTD
DECLARATION OF CONFORMITY
For the following equipment:
The product carries the CE Mark:
Product Description: 300Mbps Universal Wi-Fi Range Extender
Model No.: TL-WA850RE
Trademark: TP-LINK
We declare under our own responsibility that the above products satisfy all
the technical regulations applicable to the product within the scope of
Council Directives:
Manage the Extender’s Wi-Fi Security Settings .................... 16
Change your Admin Account ............................................. 16
Control the Wireless Devices Access to the Extender ....... 16
1
Product Overview
What can your Extender do
Introduction
This chapter covers the following topics:
Product Overview
Appearance
The TL-WA850RE 300Mbps Universal Wi-Fi Range Extender is dedicated to
Small Office/Home Office (SOHO) wireless network solutions. It will enlarge
your existing wireless network and mobility within your wireless network while
also allowing you to connect a wired device to a wireless environment.
Increased mobility and the absence of cabling will be beneficial for your network.
The extender provides two options to finish the quick setup.
Option One: an easy wireless connection to the host network (equipped with
WPS/QSS button) by Using WPS
Option Two: Using your Web Browser for installation and management.
Even though you may not be familiar with the extender, you can easily configure
it with the help of this guide. Before installing the extender, please look through
this guide to get the full information of the TL-WA850RE 300Mbps Universal WiFi Range Extender.
on the back panel.
Support for the 802.11n wireless technology
With using IEEE 802.11n wireless technology, this device can transmit wireless
data at the rate of up to 300Mbps. With multiple protection measures, including
wireless LAN 64/128-bit WEP encryption, Wi-Fi protected Access (WPA2-PSK,
WPA-PSK), the TL-WA850RE 300Mbps Universal Wi-Fi Range Extender
delivers complete data privacy.
Introduction 1
Main Features
Make use of IEEE 802.11n wireless technology
Provides multiple encryption security Types including: 64/128-bit WEP and
WPA-PSK/WPA2-PSK
Supports Built-in DHCP server
Supports Firmware Upgrade
Supports Web-based Management
Appearance
Introduction 2
Blinking
WPS connection is in process.
Strength)
Fi connection between the extender and the
LED Explanation
Name Status Indication
On The extender is connected to the router.
RE
Off The extender is not connected to the router.
On The extender’s wireless function is on.
Wireless
Off The extender’s wireless function is off.
On The extender is powered on.
Power
Off The extender is powered off.
(Ethernet)
(Signal
On The Ethernet port is connected.
Off The Ethernet port is not connected.
Indicates the Wirouter. More lit LEDs indicate a better signal strength.
Button Explanation
(Range Extender/WPS) Button: If your Wireless router supports WPS
or QSS function, you can press the WPS or QSS button and then press the
RE button to establish a secure connection between the Wireless router and
the extender.
RESET: This button is used to restore the extender’s factory default settings.
There are two ways to reset the extender:
Option One: With the extender powered on, use a pin to press the RESET
button until all the LEDs turn on momentarily, then release the button and
wait the extender to reboot to its factory default settings.
Option Two:Restore the default settings from “System Tools > Backup
&Restore” of the extender's Web-based Management page.
Ethernet Port: Five 10/100/1000Mbps RJ45 Ethernet ports used to add
wireless connectivity to an Ethernet-enabled device such as Internet TV,
DVR, Gaming console and so on. Please note that this port is not allowed to
be connected with router.
Connect the Extender to the Internet 3
2
Before You Begin
Please read this guide carefully before installing and using the device. The
operating distance range of your wireless connection can vary significantly
depending on the physical position of the wireless devices. Factors that can
Connect the Extender
weaken signals by getting in the way of your network’s radio waves are metal
appliances or obstructions, and walls. Typical ranges vary based on the types
of materials and background RF (radio frequency) noise in your home or office.
to the Internet
In order to optimize the performance of TL-WA850RE, please follow the
This chapter covers the following topics:
Before You Begin
Basic Requirements
instructions below to achieve an ideal location (please make sure it is always
within the wireless coverage of the wireless router).
● Half-way Between - Generally, the ideal location for TL-WA850RE is half-
way between the Wireless router and Wireless Client. If the wireless
signal is not satisfactory, you may place TL-WA850RE somewhat nearer
to the Wireless router.
Quick Setup
● No Obstacles and Spacious - Clear obstacles in the way between TL-
WA850RE and Wireless router. It’s better to locate it in a spacious place,
such as near the corridors.
● No Interference - Choose a location away from Bluetooth devices and
other household electronics, such as cordless phone, microwave, and
baby monitor, etc., to minimize signal interference.
Connect the Extender to the Internet 4
Quick Setup
Basic Requirements
Place your extender in a well-ventilated place far from direct sunlight,
any heater or heating vent.
Leave at least 2 inches (5cm) space around the device for heat
dissipation.
Turn off your extender and unplug the power adapter in a lighting storm
to avoid damage.
Use Web browser, such as Microsoft Internet Explorer 5.0 or above,
Netscape Navigator 6.0 or above.
Operating temperature of the extender should be 0℃~40℃ (32℉
~104℉).
Operating humidity of the extender should be 10%~90%RH (Non-
condensing).
Using WPS (Wi-Fi Protected Setup)
Your router should support WPS. Otherwise, please use Using
your web browser.
1 Power On
Plug in next to your router.
2 Connect
1) Press the WPS buttonon your router.
Connect the Extender to the Internet 5
Loading...
+ 25 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.