Digital Manometer 608
TestProducts International, Inc.
The Value Leader
Visit www.testproductsintl.com
Combustion Control Ltd.
E. MEASUREMENT TECHNIQUES
1. Turn the 608 on by pressing the ON/OFF button. The display will initially read
“608” along with the selected unit of measure. After this initial display the 608
is ready for use.
Note: Follow these steps to change the unit of measure.
a) With the 608 turned off, press and hold the on/off button until the display
reads “----” and the unit annunciator flashes.
b) Release the on/off button and then press it repeatedly until the desired unit
of measure is displayed. The unit of measure will cycle through inH2O, mbar,
KPa, and PSI.
c) Once the desired unit of measure is selected, allow the 608 to turn off and
then turn it back on and proceed with testing. The 608 will turn on in the last
selected unit of measure until changed.
2. Zero the displayed reading by pressing the ZERO button.
3. Connect the 608 to the device under test.
Additional Features
Backlight - The backlight can be activated to make the display easier to see in
dark environments. Press the BL button to turn the backlight on. The
display will light up and “BL” will be displayed.To preserve battery
life, the backlight will remain on for 15 seconds and then turn off.
Auto Power Off - To extend battery life, the 608 will automatically turn off
after 20 minutes.
Case Magnets - The 608 back case is equipped with magnets and a hook.
and Hook This allows the 608 to be secured during tests.
F. ACCESSORIES
Item # Description
A009A ....................................9 Volt Alkaline Battery (included)
A774 ......................................Silicone tubing (included)
A100 ......................................Soft Carrying Pouch (optional)
Combustion Control Ltd.
Loading...