TPG TD-W9970 Configuration Manual

1

Modem Conguration Guide

TD-W9970 (ADSL2+ HOME BUNDLE)

Windows 10

IMPORTANT MESSAGE

Your modem has already been pre-configured, you do not need to follow each step of the set-up guide but should retain
this document in case you need to manually configure your equipment.

To configure your PC/Laptop with your wireless password including changing your wireless password, please
proceed to step 4.

Contents

1. Physical Connection

2. Network Configuration

3. Configuring Modem

4. Configuring Wireless

5. Change of Password

1. PHYSICAL CONNECTION

Have your modem powered on and connected directly to your PC via Ethernet Cable before you begin, as these
instructions are based on wired Ethernet connection

For further information, please see wiring diagram and instructions for your ADSL2+ Home Bundle service below.

• ADSL2+ Home Bundle Wiring Diagram

2. NETWORK CONFIGURATION

PPPoE connection does not require you to have an IP address or DNS settings manually encoded on your network card.
PPPoE connection uses authentication to establish the Internet connection and once connected your modem will be
assigned an IP and DNS settings from TPG.

To begin, your PC needs to receive a private IP address from the modem. Most modems have DHCP enabled by default
that will take care of this.

TD-W9970

2

Modem Conguration Guide TD-W9970

To ensure your Network Card is ready for this, please follow the following steps:

A. Click Start -> Settings -> Network and Internet -> Ethernet ->

Change adapter options

B. Right click on Ethernet, and then click Properties

C. Under Ethernet properties, select Internet Protocol Version 4

TCP/IP v4 and then click Properties

D. Ensure “Obtain an IP address automatically” is selected

E. Ensure “Obtain DNS server address automatically” is selected

F. Click OK