Toy State 94130F27 User Manual
CMY
FAR_94130_16SC_RACING_ENG_IM_042015.pdf 1 20/4/15 11:48 am
8+
ASST
#94130
C
M
Y
CM
MY
CY
K
CONTROLLER
x3
BATTERIES NOT INCLUDED BATTERIES NOT INCLUDED
VEHICLE
x4
Important! Carefully read the Owners Manual before play!
CMY
FAR_94130_16SC_RACING_ENG_IM_042015.pdf 2 20/4/15 11:48 am
PRECAUTION
WARNING! CHOKING HAZARD
Small parts. Not for Children under 3 years.
Only operate the product and its accessories when fully
assembled and in accordance with this manual!
• Do not use this vehicle in water, mud, or sand.
• This product and its accessories are not suitable for children under the age of 36 months, because of small
parts that can be swallowed.
• Intended for children age 8 and older.
• Adult supervision strongly recommended.
• Drive your vehicle in a safe area away from people, pets, cars, etc.
• Do not drive on streets or after dark.
• Do not touch or try to pick up the vehicle when it is in motion. Wait until it has stopped completely.
• Keep hair, fingers, face and loose clothing away from front and rear wheels while the vehicle is switched on
or while the transmitter is operating.
• Do not drive the vehicle toward walls or other hard objects.
• Be a responsible operator!
C
M
Y
CM
MY
CY
K
• Do not drop or give impact to the product and its accessories.
• Check if a near transmitter produces interference or signals with the same frequency. In such a case, move
to another location or try again after a while.
• Never attempt to disassemble or modify the product or its accessories.
• Regularly inspect the antennas for cracks or breaks. Do not bend the transmitter antenna. Do not use the
transmitter if the antenna is broken.
BATTERIES
IMPORTANT BATTERY SAFETY INFORMATION
CAUTION: TO AVOID BATTERY LEAKAGE:
NOTE: BATTERIES MUST BE RECYCLED OR DISPOSED PROPERLY.
Contact your local area office of solid waste management or other appropriate
local agency for information.
• Make sure the batteries are inserted with correct polarity and follow the toy and battery manufacturer's
instructions.
• Use only battery type(s) recommended.
• Do not attempt to short-circuit, charge, disassemble or heat batteries.
• Do not dispose of batteries in fire or make them wet.
• Do not mix or use new and old batteries together.
• Do not mix or use different types of batteries together.
• Non-rechargeable batteries are not to be recharged because of the danger of eruption.
• Remove rechargeable batteries from the product before charging.
• Rechargeable batteries are only to be charged under adult supervision and follow the battery and charger
manufacturer's instructions.
• Battery replacement should be done in presence of an adult.
• Remove batteries from the product for storage. Batteries may be hot.
• After use, be sure to turn the switch off.
• Remove weak or exhausted batteries from the product.
• Dispose batteries safely and properly, according to your local requirements.
STRONG BATTERY MEANS OPTIMUM PERFORMANCE
ON
OFF
Save the battery by turning off vehicle when not in use.
1
FAR_94130_16SC_RACING_ENG_IM_042015.pdf 3 20/4/15 11:48 am
ANTENNA ASSEMBLY
CMY
1
Insert antenna wire
from product into tube
2
Slide tube down antenna
wire and into hole
in product
3
Tie knot with any
remaining antenna wire
(Do not pull wire tight)
BATTERY INSTALLATION
TRANSMITTER
1
3
1.5V
C
M
Y
CM
MY
CY
2
1.5V
1.5V
NOTE:
Moving the sticks turns it on automatically.
VEHICLE
K
2
1
OFF
3
1. To remove battery lid, loosen screw to
open.
2. Slide open the battery lid in the
direction as shown in the figure, while
lightly pressing its center.
3. Insert 1.5V (AAA/LR03) batteres x3
with the polarity (+/-) as shown on
the bottom of battery compartment.
Replace the battery lid, following the
removal procedure in reverse.
There is no on/off switch on the Transmitter.
1. Turn off vehicle.
ON
2. Loosen screw to open battery lid.
3. Remove battery lid.
4. Insert 1.5V (AA/LR6) batteries x4
into battery compartment with
correct polarity (+/-). Place
battery lid back in position and
lock properly.
4
NOTE:
For best performance, always use alkaline batteries only. To remove the batteries, reverse the
installation procedure.
2
1.5V
Loading...