CLEANING AND MAINTAINING
Brush areas where dirt and dus t
get trapped.
Wipe body off with a soft rag or tact cloth. Do not clean vehicle with chemicals or water.
FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following t wo conditions:
(2) this device must accept any interference received, including interference that may cause undesired operation.
Warning : Changes or modifications to this unit not expressly approved by the part y responsible for compliance could void the user’s
authority to operate the equipment. N OTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful inter ference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to r adio or television reception,
which can be determined by turning the equipment of f and on, the user is encouraged to try to correct the interference by one or more of
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
(1) this device may not cause harmful interference, and
- Reorient or relocate the receiving antenna.
- Increase the separ ation between the equipment and receiver.
- Consult the dealer or an experienced radio /TV technician for help.
NOTE:
the following measures:
INDUSTRY CANADA NOTICE: CANADA ONLY
Operation is subject to the follwing two conditions: 1). This device may not cause harmful interference. 2). This device must accept any
This radiocommunication device complies with all the requirements of Industry Canada Standard RSS-310.
interference received, including interference that may cause undesired operation.
Field Strength and measurement distance: 27.195MHz - 60.49 dBµ V/m at 3 meter. 49.890MHz - 61.61 dBdB V/m at 3 meter.
This device complies with the limits of standard RSS-310 issue 1.
MANUFACTURER’S NOTE
“Modifi cations not authorized by the manufacturer may void users authority to operate the device.”
ATTENTION PARENTS
This toy and all accessories need to be periodically examined for potential hazards and any potentially hazardous
parts be repaired or replaced.
www.toystate.com
For questions, e-mail our Consumer Service Dept. at
consumerservice@toystate.com
Or Call 1-877-473-8015
WARNING: Not suitable for children under 36 months
MADE IN SHENZHEN, CHINA
TOY STATE INTERNATIONAL LIMITED
66 MODY ROAD, KOWLOON, HONG KONG
IN THE INTEREST OF BETTER QUALITY AND VALUE, WE ARE CONSTANTLY IMPROVING AND UPDATING OUR PRODUCTS. CONSEQUENTLY, PICTURES IN THIS
INSTRUCTION SHEET MAY SOMETIMES DIFFER FROM THE MODEL ENCLOSED.
4
90440_HWrc_IM_03212014_OP_FAR.indd 1 14/4/14 5:11 pm
due to small parts. Choking hazard.
HOT WHEELS and associated trademarks and
trade dress are owned by, and used under license
from Mattel. ©2014 Mattel. All Rights Reserved.
ENG
www.toystate.com
90440_HWrc_IM_03212014_OP_FAR.indd 2 14/4/14 5:11 pm