Toy State 90430F27 User Manual

CLEANING AND MAINTAINING

Brush areas where dirt and dus t
get trapped.

Wipe body off with a soft rag or tact cloth. Do not clean vehicle with chemicals or water.

FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE

This device complies with Part 15 of the FCC Rules. Operation is subject to the following t wo conditions:

(2) this device must accept any interference received, including interference that may cause undesired operation.

Warning : Changes or modifications to this unit not expressly approved by the part y responsible for compliance could void the user’s

authority to operate the equipment. N OTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful inter ference

in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used

in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful interference to r adio or television reception,

which can be determined by turning the equipment of f and on, the user is encouraged to try to correct the interference by one or more of

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

(1) this device may not cause harmful interference, and

- Reorient or relocate the receiving antenna.

- Increase the separ ation between the equipment and receiver.

- Consult the dealer or an experienced radio /TV technician for help.

NOTE:

the following measures:

MANUFACTURER’S NOTE

“Modifi cations not authorized by the manufacturer may void users authority to operate the device.”

ATTENTION PARENTS

This toy and all accessories need to be periodically examined for potential hazards and

any potentially hazardous parts be repaired or replaced.

www.toystate.com

For questions, e-mail our Consumer Service Dept. at
[e-mail]
Or Call 1-877-473-8015

MADE IN SHENZHEN, CHINA

TOY STATE INTERNATIONAL LIMITED

66 MODY ROAD, KOWLOON, HONG KONG

IN THE INTEREST OF BETTER QUALITY AND VALUE, WE ARE CONSTANTLY IMPROVING AND UPDATING OUR PRODUCTS.
CONSEQUENTLY, PICTURES IN THIS INSTRUCTION SHEET MAY SOMETIMES DIFFER FROM THE MODEL ENCLOSED.

WARNING: Not suitable for children under 36 months
due to small parts. Choking hazard.

HOT WHEELS and associated trademarks and
trade dress are owned by, and used under license
from Mattel. ©2014 Mattel. All Rights Reserved.

OWNER’S MANUAL

RADIO CONTROL

JUMP & FLIP
STUNTS!

8+

#90430

Contains 1 x 3.7V LiPo bat tery pack. Requires 3 x 1.5 V AA ( LR6) alkaline batteries ( not included).
Batteries or battery packs must be recycled or disposed of properly. When this product has reached the
end of its useful life it should not be disposed of with other household waste. The Waste Electrical and
Electronic Equipment Regulations require it to be separately collected so that it can be treated using

and human health from soil and water contamination by any hazardous substances, decrease the resources required to make
new products and avoid using up land fill space. Please do your part by keeping this product out of the municipal waste s tream !
The “wheelie bin” symbol means that it should be collected as “waste electrical and electronic equipment”. You can return an old
product to your retailer when you buy a similar new one. For other options, please contact your local council.

the best available recovery and recycling techniques. This will minimize the impact on the environment

4

ENG

www.toystate.com

CONTROLLER VEHICLE

3 x AAA/LR03

Batteries Not Included Included (Non-Removable)

RECHARGABLE LiPo

Important! Carefully read the Owners Manual before play!

ONOFF

ONOFF

PLAYDEMO OFF

PLAY CHARGEOFF

ONOFF

ONOFF

PLA

Y

PLAY CHARGEOFF

Play Charge

OFF

GETTING STARTED

What’s included

Remove the R/C vehicle, controller and charger from the package.
Insert batteries into the controller and use the charger to fully
charge the internal batter y in the vehicle to begin play ( see “Batter y
Installation” section for further details ).

Play Charge

OFF

OPERATING R/C VEHICLE

Turn switch located on back of R/C vehicle to the PL AY position (as shown).

CAUTION

Important Battery Information

• Dispose of batteries properly.

• Do not dispose of batteries in fire.

• Use only batteries of the type recommended.

• Do not mix alkaline, standard (carbon-zinc) or rechargeable

(nickel-cadmium) batteries.

• Do not mix old and new batteries.

• Remove batteries from R/C controller if vehicle will not be

used for a long period of time.

• Do not attempt to remove the LiPo battery from the vehicle.

Press button

to jump!

BATTERY INFORMATION

CONTROLLER

TO REPLACE THE BATTERIES

LOOSEN SCREW TO OPEN

Drive forward

& reverse

1.5V

1.5V

1.5V

1. To remove battery cover, loosen screw to open.

2. Insert 3 “AAA” batteries into the controller. Be sure the + and – are
properly matched.

NOTE: For best performance, always use alkaline batteries only.

Spins left

& Right

Press button to
load the spring!

R/C VEHICLE

Play Charge

1.

OFF

3.

Power Supply:
Rating: DC 5.5V, 500mA

1. Ensure Vehicle is in ‘charge’ mode.

2. Securely plug the charger cable into the charging port.

3. Plug the wall adaptor into an electrical outlet.
The LED light on the rear of the vehicle indicates that it is charging. After a full

charge, the light will go out. This should take about 120 minutes.

FPO

Charge port

Charge LED Light

2.

Full function R/C with spins!

Jumps and does flips!

HOW TO JUMP

WARNING! ONLY USE THE WALL CHARGER INCLUDED TO CHARGE JUMP & FLIP STUNTS!.

Internal LiPo Battery Removal Instructions: At the end of this product’s life span, the internal battery must be removed by an adult and
recycled. Do not puncture, cut, tear, compress, bend or deform the battery in any way. Ensure the vehicle is turned OFF before removal. Use
a screwdriver to remove 4 screws from the bottom of the vehicle. This separates the body from the chassis. Next, remove 2 more screws
from the chassis to remove the plastic engine cover. The battery is located on the inside of this cover. Pull the battery out and disconnect the
battery from the electronics by pulling on the plastic connector located at the end of the battery wires. Dispose of the battery in accordance
with your local battery recycling or disposal laws.

ENG ENG

1

Jumpin’ Stunts is capable of jumping in the air while flipping. Be careful ! The jump up lever on the bot tom of the vehicle should not be
placed above, below or near any person, animal or breakable object while turned on.

1. Hit the ‘Wind Spring’ but ton on the controller. You’ll hear the car prepare to jump by winding an internal spring. The LED light in the
car and controller will star t to flash.

2. After a few seconds the lights stop flashing. Now the vehicle is ready to jump !

3. Check that the jump zone is clear of people, animals and breakable objects. Hit the forward or rever se drive button at the same time
as the ‘Jump’ button on the controller for Jumpin’ Stunts!

Note! The vehicle mus t be driving forward or reverse in order to jump.

After play, always turn vehicle off. Remove batteries from controller when not in use or when storing.

Leakage may occur and cause damage if left for a long period of time.

2

ENG

TROUBLESHOOTING AND CARE FOR R/C VEHICLE

LIMITED RADIO CONTROL RANGE
While R/C vehicle may be visible at a distance, full operational
control may be lost. Hold controller high in the air and direct
vehicle back.

• Ensure the “Wind Spring” but ton has be pushed and the spring ha s finished winding.

• The vehicle must be driving forward or backward when the jump but ton is pressed.

R/C VEHICLE

DOES NOT JUMP

R/C VEHICLE

DOES NOT MOVE

R/C VEHICLE

MOVES BY ITSELF

R/C VEHICLE

RUNS SLOWLY

PERFORMANCE DROP,

INCONSISTENT MOVEMENT

OR FAILS TO RUN

• Ensure the vehicle is on a horizontal surface, right side up and the wheels are
touching the ground.

• The car has been lef t idle for over 1 minute and the spring has automatically unwound.

• Check to ensure the vehicle is in the “PLAY” position and has a charged bat tery.

• Are the + and – contacts correctly matched in the controller?

• Are the metal contact tabs touching, rusty or dirty in controller?

• Are there batteries in the controller?

• Is the power switch on the vehicle turned on?

• Are the batteries weak or out of power?

• There is radio interference in the area.

• Another R/C vehicle with the same frequency is close by.

• There is radio interference in the area.

• Another R/C vehicle with the same frequency is close by.

• Are the batteries weak or out of power?

• Check batteries. I f necessary, replace the controller with new alkaline batteries or
charge the vehicle.

• Push the “reset” but ton on the back of the vehicle.

INTERFERENCE

Other radio signals may cause los s of control. Remove vehicle
from an area of inter ference.

TREAT YOUR R/C VEHICLE WELL

Radio waves control the R/C vehicle. Care for your vehicle and it will provide hours of fun!

Store in safe place. No direct sunlight. No rain or water. No sand or dust.

No Collisions. R/ C vehicle may get stuck on

ENG

Avoid water, heat, sand and high impact crashes!

carpet or grass.

Avoid running 2 vehicles with the same radio control frequencies.

3