Toy State 90420F27 User Manual

CLEANING AND MAINTAINING
OWNER’S MANUAL
6+
#90420
Brush areas where dirt and dust get trapped.
Wipe body off with a soft rag or tact cloth. Do not clean vehicle with chemicals or water.
FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE
This device complies with Par t 15 of the FCC Rules. Operation is subject to the following two conditions:
(2) this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the use
authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful inter ference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
(1) this device may not cause harmful interference, and
- Reorien
- Increase the separation between the equipment and receiver.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE:
r’s
the following measures:
t or relocate the receiving antenna.
MANUFACTURER’S NOTE
“Modifications not authorized by the manufacturer may void users authority to operate the device.”
ATTENTION PARENTS
This toy and all accessories need to be periodically examined for potential hazards and any potentially hazardous
parts be repaired or replaced.
RADIO CONTROL
ENGINE POWER
www.toystate.com
MADE IN SHENZHEN, CHINA
TOY STATE INTERNATIONAL LIMITED
66 MODY ROAD, KOWLOON, HONG KONG
IN THE INTEREST OF BETTER QUALITY AND VALUE, WE ARE CONSTANTLY IMPROVING AND UPDATING OUR PRODUCTS. CONSEQUENTLY, PICTURES IN THIS INSTRUCTION SHEET MAY SOMETIMES DIFFER FROM THE MODEL ENCLOSED.
WARNING: Not suitable for children under 36 months due to small parts. Choking hazard.
HOT WHEELS and associated trademarks and trade dress are owned by, and used under license from Mattel. ©2013 Mattel. All Rights Reserved.
CONTROLLER VEHICLE
3 x AAA/LR03 4 x AA/LR6
4
ENG
www.toystate.com
Batteries Not Included Batteries Not Included
GETTING STARTED
TO REPLACE THE BATTERIES
LOOSEN SCREW TO OPEN
1.5V
1.5V
1.5V
TO REPLACE THE BATTERIES
1.5V
1.5V
1.5V
1.5V
ONOFF
ONOFF
ONOFF
Remove the R /C vehicle and controller from the package. Insert bat teries into the R/ C vehicle and controller to begin full function play
(see “Battery Installation” section for further details).
CAUTION
Important Battery Information
Dispose of batteries properly.
Do not dispose of batteries in fire.
Use only batteries of the type recommended.
Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
Do not mix old and new batteries.
Remove batteries from R/C vehicle and controller if vehicle will not be used for a long period of time.
BATTERY INSTALLATION
CONTROLLER
1. To remove battery cover, loosen screw to open.
2. Insert 3 “AAA” batteries into the controller. Be
sure the + and – are properly matched.
Drive
Forward &
Reverse
OPERATING R/C VEHICLE
Turn ON/OFF switch located on bottom of R/C vehicle to the ON position (as shown)
Adjust Trim Switch on bottom of R/ C vehicle to ensure precision driving
Tur n
Left & Right
TROUBLESHOOTING AND CARE FOR R/C VEHICLE
LIMITED RADIO CONTROL RANGE While R/C vehicle may be visible at a distance, full operational control may be lost. Hold controller high in the air and direct vehicle back.
• Are the + and – contacts correctly matched in the controller?
R/C VEHICLE
DOES NOT MOVE
R/C VEHICLE
MOVES BY ITSELF
R/C VEHICLE
RUNS SLOWLY
• Are the metal contact tabs touching, rusty or dirty in controller?
• Are there batteries in the vehicle and controller?
• Is the power switch turned on?
• Are the batteries weak or out of power?
• There is radio interference in the area.
• Another R/C vehicle with the same frequency is close by.
• There is radio interference in the area.
• Another R/C vehicle with the same frequency is close by.
• Are the batteries weak or out of power?
INTERFERENCE Other radio signals may cause loss of control. Remove
vehicle from an area of interference.
R/C VEHICLE
1. To remove battery cover, loosen screw to open.
LOOSEN
SCREW
TO OPEN
NOTE: For best performance, always use alkaline batteries only.
ENG ENG
STRONG BATTERY MEANS OPTIMUM PERFORMANCE
Save the battery by turning off vehicle when not in use.
2. Insert 4 “AA” batteries into the vehicle. Be sure
the + and – are properly matched.
After play, always turn vehicle off. Remove batteries from controller and R/C vehicle when not in
use or when storing. Leakage may occur and cause damage if left for a long period of time.
Turns In All Directions !
Rumbling Engine!
21
ENG
PERFORMANCE DROP,
INCONSISTENT MOVEMENT
OR FAILS TO RUN
Check batteries. If necessary, replace the batteries in the R/C vehicle and controller with new alkaline batteries.
TREAT YOUR R/C VEHICLE WELL
Radio waves control the R/C vehicle. Care for your vehicle and it will provide hours of fun! Avoid water, heat, sand and
Store in safe place. No direct sunlight. No rain or water. No sand or dust.
No Collisions.
ENG
R/ C vehicle may get stuck on carpet or grass.
high impact crashes!
Avoid running 2 vehicles with the same radio control frequencies.
3
Loading...