Toy State 36665F27 Users manual

PROBLEM! CAT®MACHINE RUNS SLOWLY

• There is radio interference in the area.

• Another R/C vehicle with the same frequency is close by.

• The antenna of controller is not screwed in tight.

• The antenna is not fully extended.

• Are the batteries weak or out of power?

PROBLEM? PERFORMANCE DROP, INCONSISTENT MOVEMENT OR FAILS TO RUN

Check and replace batteries, if necessary, in CAT Machine and controller with new alkaline
batteries.

Call 1-877-473-8015 for help!

© 2011 Caterpillar
CAT, CATERPILLAR, their respective logos,
EQUIPPED TO PLAY, and "Caterpillar Yellow" and the
“Power Edge” trade dress as well as corporate and
product identity used herein, are trademarks of
Caterpillar and may not be used without permission.
www.cat.com

Toy State, a licensee of Caterpillar Inc.

RADIO CONTROL

HEAVY DUTY R/C

OWNER’S MANUAL

BATTERY REQUIREMENTS:

3 “AAA” Batteries (for Controller)
8 “AA” Batteries (for Machine)

Have Fun - Play Games @ www.toystate.com

For questions, e-mail our Consumer Service Dept. at

[e-mail]
Or Call 1-877-473-8015

MADE IN SHENZHEN, CHINA

TOY STATE INTERNATIONAL LIMITED

1 PEKING ROAD, KOWLOON, HONG KONG

IN THE INTEREST OF BETTER QUALITY AND VALUE, WE ARE CONSTANTLY
IMPROVING AND UPDATING OUR PRODUCTS. CONSEQUENTLY, PICTURES IN THIS
INSTRUCTION SHEET MAY SOMETIMES DIFFER FROM THE MODEL ENCLOSED.

Call for Help!

If you have questions about this toy

Call Toll-Free: 1-877-473-8015

Between 9:00 a.m. – 5:00 p.m. E.S.T. Monday thru Friday

Contact via e-mail: [e-mail]

www.toystate.com

MANUFACTURERS NOTE TIPS & TRICKS

“Modifications not authorized by the manufacturer may void users authority to operate the device.”

CAUTION

Important Battery Information

• Dispose of batteries properly.

• Do not dispose of batteries in fire.

• Use only batteries of the type recommended.

• Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.

• Do not mix old and new batteries.

• Remove batteries from CAT

®

Machine and controller if vehicle will not be used for a long period.

FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE

NOTE:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1). This device may not cause harmful interference.

2). This device must accept any interference received including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the use
comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These Limits are designed
to provide reasonable protection against harmful interference in a residential installation. This generates, uses and
can radiate radio frequency energy and if not installed and used in accordance
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on , the user is encouraged to try and correct the interference by
one or more of the fol

- Reorient or relocate the receiving antenna

- Increase the separation between the equipment and receiver

- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected

- Consult the dealer or an experienced radio/TV technician for help.

r’s authority to operate the equipment. Note: this equipment has been tested and found to

with the instructions, may cause

lowing measures:

STRONG BATTERY MEANS OPTIMUM
PERFORMANCE

Save the battery by turning off vehicle when not in use.

LIMITED RADIO CONTROL RANGE

While CAT
full operational control may be lost. Hold controller
high in the air and direct truck back.

INTERFERENCE

Other radio signals may cause loss of control.
Remove vehicle from an area of interference.

®

Machine may be visible at a distance,

TROUBLESHOOTING AND CARE FOR R/C TRUCKS

PROBLEM! CAT®MACHINE DOES NOT MOVE

• Are the + and –‘s contacts correctly matched in the controller?

• Are the metal contact tabs touching, rusty or dirty in controller?

• Are there batteries in the vehicle and controller?

• Is the power switch turned on?

• Are the batteries weak or out of power?

ATTENTION PARENTS

This Toy and all Accessories need to be periodically examined for potential hazards and that any
potentially hazardous parts be repaired or replaced.

PROBLEM! CAT®MACHINE MOVES BY ITSELF

• There is radio interference in the area.

• Another R/C vehicle with the same frequency is close by.

• The antenna of controller is not screwed in tight.

• The antenna is not fully extended.

61