TOYS R US 96849 Users Manual

Owner’s Manual – 2314
Read Owner’s Manual carefully and completely before operating the Motorcycle.

Battery Requirement: : One (1) 9V battery for transmitter
One (1) 7.2V battery pack for Motorcycle

Installing the Battery in the Transmitter

1. Slide the battery compartment cover in the direction
of the arrow on the cover to remove it.

2. Install the 9V battery in the compartment in
accordance to the polarity symbols (+ and -)
marked inside.

3. Replace the cover and snap it shut.

Note: When the range of transmitter decreases,

replace with a new battery.

Installing Battery in the Motorcycle

1. Turn the ON/OFF switch on the side of
the Motorcycle to OFF.

2. Loosen the screw on the battery
compartment cover located on the
bottom of the motorcycle and remove the
cover.

3. Install the 7.2V battery pack in the
compartment. Make sure the battery
pack in fully charged before use. Attach
the battery pack’s white plastic connector
to the motorcycle’s matching connector.
Do not force them together. They only
fit one way.

4. Replace the cover and secure it with the
screw.

Installing the Antenna

1. Route the loose end of the motorcycle’s antenna wire through the supplied antenna

tube.

2. Insert the tube securely into the motorcycle’s tube holder.

Driving The Motorcycle

1. Extend the transmitter’s antenna to its full
length before driving the motorcycle. For
maximum range, hold the transmitter with the
antenna as high as possible and point it
straight up.

2. Turn the Motorcycle and Transmitter’s
ON/OFF switch to ON. The LED indicator on
the transmitter illuminates.

3. Hold the front of the seat and lift the rear wheel
of the Motorcycle off the ground.

4. Push the Left Control Lever on Transmitter
forward for about 5 seconds to conducts a
warm up drive of the Motorcycle rear wheel.

5. Release the motorcycle on floor and start
driving. Be sure to run in a large open area
as the unit requires more space to make a full
turn than most radio controlled vehicles.