Toyota Frameless User guide

Southeast Toyota Distributors, LLC

Page 1 of 15

Rev.C.01.30.15

Doc. 14.126.00 Business Partner: J25 PIO / DIO Rev. A 02/02/15

Toyota Tacoma 2015 Frameless® EC Mirror w/ Compass & HomeLink®

Part Number: 00016-00463
Accessory Code: ME4000

Conflicts

Note: None

Kit Contents

Item # Quantity Reqd. Description
1 1 Frameless® Mirror w/Compass

& HomeLink®
2 1 Wire Harness Cover
5 1 Main Power Wire Harness

Hardware Bag Contents

Item # Quantity Reqd. Description
1 2 Red T-Taps
2 2 Red Spade Connectors
3 10 Wire Ties
4 3 Foam Tapes
5 2 Quick Reference Guides

Additional Items Required For Installation

Item # Quantity Reqd. Description

Recommended Tools

Safety Tools

Safety Glasses

Special Tools

Installation Tools

Needle Nose Pliers 10mm Socket
Screw Gun Torque Wrench-48inch lbs

T20 Torx Bit/Driver Ratchet/Driver
#2 Phillips Bit
Nylon Tool
Wire crimping tool
Side cuts
Dark Towel/ Cloth

Special Chemicals

(Car Battery)

Color Applicability/Trim Level

Part Description

Frameless® EC Mirror w/Compass
and HomeLink®
Main Power Wire Harness 00016-00463-02

Part Number

00016-00463-01

General Applicability

All 2015 Tacoma Models

Recommended Sequence of Application

Item # Accessory
1
2
3

*Mandatory

Toyota Tacoma Frameless® EC Mirror w/ Compass & HomeLink®

Southeast Toyota Distributors, LLC

Page 2 of 15

Rev.C.01.30.15

Care must be taken when installing this accessory to ensure damage does not occur to the vehicle.
The installation of this accessory should follow approved guidelines to ensure a quality
installation.
These guidelines can be found in the "Accessory Installation Practices" document.

This document covers such items as:

• Vehicle Protection (use of covers and blankets, cleaning chemicals, etc.).

• Safety (eye protection, rechecking torque procedure, etc.).

•

Vehicle

• Electrical Component

Disassembly/Reassembly (panel removal,

Disassembly/Reassembly (ba

part storage, etc.).

ttery disconnection, connector removal, etc.).

Figure 1

1. Disconnect the negative battery cable.
See Figure 1.

Southeast Toyota Distributors, LLC

Page 3 of 15

Rev.C.01.30.15

Toyota Tacoma Frameless® EC Mirror w/ Compass & HomeLink®

Figure 2

2. Remove the screw. Disengage the 2 clips
and 3 claws. Disconnect the connectors and
remove the roof console box assembly. See
figure 2.

Figure 3

3.

Using a T20 "TORX" socket wrench,

remove the screw and inner rear view
mirror assembly. See figure 3.

Toyota Tacoma Frameless® EC Mirror w/ Compass & HomeLink®

Southeast Toyota Distributors, LLC

Page 4 of 15

Rev.C.01.30.15

4. Using side cuts, trim the original harness
back 87 inches from the end of the spade
connectors and ring terminal. Pull/Separate
the ground wire from the main power
harness approximately 6 inches. See figure
4a and 4b.

Figure 4a

Figure 5

Figure 4b

5. Strip the main power harness ground wire
back 1/4 inch. Make sure to not damage the
wire strands. Using the new spade
connector provided, connect the black
ground wire. Make sure the wire and spade
connector have made a good connection
and crimp. See figure 5.

Toyota Tacoma Frameless® EC Mirror w/ Compass & HomeLink®

Southeast Toyota Distributors, LLC

Page 5 of 15

Rev.C.01.30.15

6. Strip the main power harness power wires
back 1/4 inch. Make sure to not damage the
wire strands. Twist the two stripped ends
together. Using the new spade connector
provided, connect the black and black/white
tracer wires to one connector. Make sure
the wires and spade connector have made a
good connection. See figure 6.

Figure 6

Note: Remove fingerprints, smudges, dirt, etc.
from mirror and windshield with glass cleaner.

Figure 7a

7. Mount the Frameless® EC Mirror
w/Compass & HomeLink® in reverse of
original factory mirror removal. Slide
and attach the rearview mirror assembly
and tighten mirror set screw with a T20
torx bit or driver. DO NOT over tighten
screw. See figure 7a and 7b.

Do not use power tools to tighten
screw. Hands tighten only.

Figure 7b

Southeast Toyota Distributors, LLC

Page 6 of 15

Rev.C.01.30.15

Toyota Tacoma Frameless® EC Mirror w/ Compass & HomeLink®

Figure 8

Figure 9a

8. Route the mirror harness to overhead
console opening using the precut notches
on the front of the headliner. See figure 8.

9. Install the wire harness cover over the wire
harness. Seat the bottom of the cover
securely to base of the mirror. Extend the
top of the cover fully into headliner. See
figure 9a and 9b.

Figure 9b

Toyota Tacoma Frameless® EC Mirror w/ Compass & HomeLink®

Southeast Toyota Distributors, LLC

Page 7 of 15

Rev.C.01.30.15

10. Connect the mirror harness to the mirror
main power harness. Make sure both
connectors are fully engaged. Wrap foam
tape around conectors. See figure 10.

Figure 10

Figure 11

11. Locate roof connector I8. Carefully
remove it from the headliner. See figure

11.

Southeast Toyota Distributors, LLC

Page 8 of 15

Rev.C.01.30.15

Toyota Tacoma Frameless® EC Mirror w/ Compass & HomeLink®

T-Tap the main power
harness power wires to
Pin 1 light green wire in
connector I8.

Figure 12a

T-Tap the main power
harness ground wire to
Pin 2 white/black wire
in connector I8.

12.

Pull the factory tape back. T-Tap the main

power harness power wires to Pin 1 light
green wire in connector I8. See figure 12a
and figure 12b. T-Tap the main power
harness ground wire to Pin 2 white/black
wire in connector I8. See figure 12a and
figure 12b.

Figure 12b

Southeast Toyota Distributors, LLC

Page 9 of 15

Rev.C.01.30.15

Toyota Tacoma Frameless® EC Mirror w/ Compass & HomeLink®

Figure 13

Figure 14

13.

Secure the harness to the front center of the

headliner with one (1) piece of foam tape.
See figure 13.

Connect the connectors. Install the

14.
overhead console. Engage the 2 clips and 3
claws. Install the screw. See figure 14.

Southeast Toyota Distributors, LLC

Page 10 of 15

Rev.C.01.30.15

Toyota Tacoma Frameless® EC Mirror w/ Compass & HomeLink®

Figure 15

Figure 16

15. Place owner’s cards in the glove box. See
figure 15.

16. Connect the negative battery cable. See
figure 16.

Torque: 48in.*lbf

Southeast Toyota Distributors, LLC

Page 11 of 15

Rev.C.01.30.15

Toyota Tacoma Frameless® EC Mirror w/ Compass & HomeLink®

Figure 17

17. Compass Zone Setting.

(a) With display turned ON, push the
mirror power button for 3 seconds or until
a number is displayed in the display
window.

(b) Refer to the Zone Map and toggle
button until correct zone is displayed. See
figure 17.

(c) Release button.

(d) The display will return to normal
compass mode (showing either a "C" or a
directional heading) within 10 seconds of
no switch activity.

Calibrate Compass.

18.

(a) If a "C" is displayed in window, drive
the vehicle in one circle at less than 5 mph.

(b) Correct compass heading should now
be displayed.

NOTE: Correct compass zone must be
selected prior to compass calibration to ensure
accurate calibration. If the vehicle is driven in
a new zone, repeat zone selection procedure.

Toyota Tacoma Frameless® EC Mirror w/ Compass & HomeLink®

Southeast Toyota Distributors, LLC

Page 12 of 15

Rev.C.01.30.15

Checklist - these points MUST be checked to
Ensure a quality installation.

Check: After Installation

Vehicle should be in a fairly well lit area.
Turn ignition (ACC power) to ON.

Auto-dimming feature:

Cover the forward-looking light sensor
(located on the back of the mirror).

Mirror clears:

Remove cover from photocell.

Compass Feature:

Look at the mirror compass display.

Look For:

Verify green LED is on. If it is not ON
press ON / OFF button - confirm LED is
ON.

Verify mirror darkens.

Mirror returns to clear state.

Correct compass heading should now be
displayed. If a "C" is displayed in window,
calibrate the compass.

Operation Instruction Cards

.

HomeLink Feature:

Look at the mirror’s (3) HomeLink buttons.

Press the mirror’s (3) HomeLink buttons.

Overhead Console:

Check dome light.

Check the Sunroof if applicable.

Place in the vehicle glove box.

Verify all (3) buttons are illuminated
when the vehicle ignition is ON.

HomeLink icon will appear in mirror.
Press button again to stop the icon from
flashing.

Verify the dome light functions properly by
switch and when opening doors.

Verify the sunroof functions properly.

Toyota Tacoma Frameless® EC Mirror w/ Compass & HomeLink®

Southeast Toyota Distributors, LLC

Page 13 of 15

Rev.C.01.30.15

Block Diagram

Frameless® EC Mirror w/Compass & HomeLink®

Applies to SET P/N 00016-00463 2015 Tacoma

1

I8

10A Fuse
IG1 NO.2

LG

T-Tap the main power harness
power wires to Pin 1 light green wire
in connector I8.

B‐W

IMH1

Frameless® EC Mirror w/Compass

B

1

IMH1

HomeLink Module

and HomeLink®



SET P/N 00016-

SET P/N 00016-00463-01

T-Tap the main power harness
ground wire to Pin 2 white/black
wire in connector I8.

6

IMH1

2

B

W‐B

I8

2

Toyota Tacoma Frameless® EC Mirror w/ Compass & HomeLink®

Southeast Toyota Distributors, LLC

Page 14 of 15

Rev.C.01.30.15

Checking the Harness Pin outs:

Connector IMH1: Frameless® EC Mirror w/Compass Power
Harness Connector

Connector view is from the front (pin side)

If feedback from the harness on any of the pins does not match the results shown
in the Proper Operation field below, check the connection to the vehicle wiring
and re-test.

Pin Wire Color Test Reference Proper Operation

1 Black w/White Trace Pin 1 to ground Approx. 12 VDC with switch in ON position

Approx. 0 VDC with switch in OFF position

2 Black

6 Black

Pin

1 Black w/White Trace Ignition
2 Ground Ground
6 Black

Wire Color Circuit

Pin 2 to ground Always Continuity

Pin 3 to ground Approx. 12 VDC with switch in ON position

Battery

Approx. 0 VDC with switch in OFF position

Toyota Tacoma Frameless® EC Mirror w/ Compass & HomeLink®

Southeast Toyota Distributors, LLC

Page 15 of 15

Rev.C.01.30.15

Vehicle Connector I8 Circuit