Toyota Corolla 2004 Repair Manual - ROOF DRIP SIDE FINISH MOULDING CENTER LH

76–17

–EXTERIOR/INTERIOR TRIM ROOF DRIP SIDE FINISH MOULDING CENTER LH

ROOF DRIP SIDE FINISH MOULDING CENTER LH

760I2–02

REPLACEMENT

HINT:

 Use the same procedures for the RH side and LH side.
 The installation procedures are the removal procedures in reverse order. However, only installation

procedures requiring additional information are included.

Front Side

Rear Side

Tape

15 (0.59)

17 (0.67)

mm (in.)

Clip

B58072

B59795

1. REMOVE ROOF DRIP SIDE FINISH MOULDING
CENTER LH

(a) Apply protective tape onto the circumference of the

moulding for protection.

(b) Using a remover for the roof moulding, release the en-

gagements of the clips both in the front and rear ends of
the moulding. Then remove the moulding.

NOTICE:

 Do not remove the clips.
 If clips are damaged during removal or removed acci-

dentally, replace them.

2. INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP
NO.1

NOTICE:
Step 2 should be performed only when replacing the clips.

(a) Remove the double–sided tape that remains on the

mounting surface of the body, and then clean the surface
with white gasoline.

(b) Using a heat light, heat the clip installation surfaces of the

body.

Heating temperature:

Item Temperature

Body 40 to 60C (104 to 140F)

Moulding 20 to 30C (68 to 86F)

NOTICE:
Do not heat the body and moulding excessively.

(c) Set new clips in the positions as shown in the illustration,

and press–fit those clips by hand to install them.

HINT:
Clips for the roof drip side finish moulding are supply parts.
(d) After press–fitting the clips, wait at last 30 minutes. Then

install the moulding.

HINT:

 Initial hardening time: 30 minutes
 Prefect hardening time: 24 hours

2004 COROLLA (RM1037U)

1872Author: Date: