Toyota Corolla 2004 Repair Manual - REAR BUMPER

76–5

–EXTERIOR/INTERIOR TRIM REAR BUMPER

760I7–02

REPLACEMENT

HINT:
Installation is in the reverse order of the removal. But the installation is indicated only when it has a point.

1. REMOVE SPARE WHEEL COVER ASSY

2. REMOVE REAR FLOOR FINISH PLATE

(a) Remove the 3 clips.
(b) Using a moulding remover, remove the rear floor finish

plate.

B59106

3. REMOVE LUGGAGE COMPARTMENT TRIM COVER
INNER LH

(a) Remove the 4 clips and the luggage compartment trim

cover.

(b) Employ the same manner described above to the other

side.

4. REMOVE LUGGAGE COMPARTMENT TRIM COVER
INNER RH

B59107

B59109

B59108

5. DISCONNECT REAR BUMPER SIDE SEAL LH

(a) Remove the clip and a part of the rear bumper side seal,

as shown in the illustration.

HINT:
Do not remove the lower side clip.
(b) Employ the same manner described above to the other

side.

6. DISCONNECT REAR BUMPER SIDE SEAL RH

7. REMOVE REAR BUMPER COVER

(a) Remove the 4 nuts.

2004 COROLLA (RM1037U)

1860Author: Date:

76–6

–EXTERIOR/INTERIOR TRIM REAR BUMPER

(b) Remove the 2 screws and 6 clips.
(c) Disengage the hook, and remove the rear bumper cover.

Hook

B59110

8. REMOVE REAR BUMPER ENERGY ABSORBER

9. REMOVE REAR BUMPER REINFORCEMENT NO.2

(a) Remove the rear bumper reinforcement No. 2 from the rear bumper energy absorber.

10. REMOVE REAR NO.2 SPOILER SUB–ASSY (W/ REAR SPOILER)

(a) Remove the 5 retainers, screw and the rear spoiler.
(b) Employ the same manner described above to the other side.

11. REMOVE REAR NO.1 SPOILER SUB–ASSY (W/ REAR SPOILER)

12. REMOVE BUMPER MOULDING SET BOLT NO.1

13. REMOVE REAR BUMPER REINFORCEMENT NO.1

(a) Remove the 4 nuts and rear bumper reinforcement No. 1.

14. REMOVE REAR BUMPER ARM LH

(a) Remove the 3 bolts and rear bumper arm.
(b) Employ the same manner described above to the other side.

15. REMOVE REAR BUMPER ARM RH

16. INSTALL REAR BUMPER ARM LH

(a) Install the rear bumper arm with the 3 bolts.

Torque: 36 N⋅m (367 kgf⋅cm, 27 ft⋅lbf)

(b) Employ the same manner described above to the other side.

17. INSTALL REAR BUMPER ARM RH

18. INSTALL REAR BUMPER REINFORCEMENT NO.1

(a) Install the rear bumper reinforcement No. 1 with the 4 nuts.

Torque: 36 N⋅m (367 kgf⋅cm, 27 ft⋅lbf)

19. INSTALL REAR BUMPER COVER

(a) Install the rear bumper cover with the 2 screws, 8 clips and 4 nuts.

Torque: 5.5 N⋅m (56 kgf⋅cm, 49 in.⋅lbf) for nuts

2004 COROLLA (RM1037U)

1861Author: Date: