76–10
–EXTERIOR/INTERIOR TRIM OUTSIDE MOULDING
OUT SIDE MOULDING
REPLACEMENT
HINT:
Use the same procedures for the RH side and LH side.
7610C–02
Protective
Tape
B57422
1. REMOVE OUTSIDE MOULDING
(a) Put protective tape around the moulding.
(b) Insert a piano wire between the vehicle body and mould-
ing.
(c) Tie objects that can serve as handles (for example, wood-
en blocks) to all wire ends.
(d) Pull the piano wire and scrape off the double–sided tape
that holds the moulding to the vehicle body.
NOTICE:
If reusing the moulding, take care not to damage the
moulding.
Becareful not to damage the body.
(e) Remove the moulding.
2. INSTALL OUTSIDE MOULDING LH
(a) Using a heat light, heat the body.
Heating temperature: 40 to 60C (104 to 140F)
NOTICE:
Do not heat the body excessively.
(b) Remove the double–sided tape from the body.
(c) Wipe off the stains with cleaner.
(d) Clean the moulding (if reusing).
(1) Using a heat light, heat the body.
Heating temperature: 20 to 30C (68 to 86F)
NOTICE:
Do not heat the moulding excessively.
(2) Remove the double–sided tape from the moulding.
(3) Wipe off the stains with cleaner.
(4) Apply new adhesive tape to the moulding as shown
the illustration.
in
2004 COROLLA (RM1037U)
Double–sided Tape
B59015
1865Author: Date:
76–11
–EXTERIOR/INTERIOR TRIM OUTSIDE MOULDING
(e) Using a heat light, heat the body and moulding.
Heating temperature:
Item Temperature
Body 40 to 60C (104 to 140F)
Moulding 20 to 30C (68 to 86F)
NOTICE:
Do not heat the body and moulding excessively.
(f) Remove the peeling paper from the double–sided tape on
the moulding face.
NOTICE:
When the peeling paper is removed, take care that no dirt
or dust contaminates the adhesive.
(g) Affix the moulding to the body, as shown in the illustration.
NOTICE:
Do not apply excessive force onto the moulding. Use
steady pressure with your thumbs.
2.6 (0.10)
26 (1.02)
66 (2.60)
190 (7.48)
1.5 (0.059)
223 (8.78) 233 (9.17)
300 (11.81)
240 (9.45)
26 (1.02)
mm (in.)
B59794
2004 COROLLA (RM1037U)
1866Author: Date: