75–20
–ENGINE HOOD/DOOR REAR DOOR
750DG–02
OVERHAUL
HINT:
Installation is in the reveres order of the removal. But the installation is indicated only when it has a
point.
In the RH side, work in the same procedure as in the LH side.
1. REMOVE REAR ARMREST ASSY LH
Clip
Clip
(a) Using a screwdriver, remove the rear armrest.
HINT:
Tape the screwdriver tip before use.
: Claw
: Claw
B59505
2. REMOVE POWER WINDOW REGULATOR SWITCH
ASSY REAR (W/ POWER WINDOW)
(a) Using a screwdriver, remove the power window regulator
switch assembly.
HINT:
Tape the screwdriver tip before use.
B59797
3. REMOVE REAR DOOR WINDOW REGULATOR
HANDLE ASSY (W/O POWER WINDOW)
(a) Using a shop rag, remove the snap ring.
(b) Remove the rear door window regulator handle and plate.
BO0020
Clip
2004 COROLLA (RM1037U)
4. REMOVE REAR DOOR TRIM BOARD SUB–ASSY LH
(a) Remove the 3 screws.
(b) Using a screwdriver, disengage the clips, then pull the
trim board upward to remove it.
HINT:
Tape the screwdriver tip before use.
B59009
1846Author: Date:
–ENGINE HOOD/DOOR REAR DOOR
5. REMOVE REAR DOOR INSIDE HANDLE SUB–ASSY
LH
(a) Remove the inside handle and then disconnect the 2
cables from the inside handle.
B58050
6. REMOVE REAR DOOR SERVICE HOLE COVER LH
(a) Disconnect each connector and remove the rear door service hole cover.
NOTICE:
Remove the remaining tape on the body side.
7. REMOVE REAR DOOR BELT MOULDING ASSY LH (See page 76–13 )
8. REMOVE REAR DOOR GLASS RUN LH
(a) Remove the rear door glass run.
75–21
9. REMOVE REAR DOOR INSIDE PANEL PLATE LH
(a) Remove the 4 screws and rear door inside panel plate.
B59017
10. REMOVE REAR DOOR WINDOW DIVISION BAR
SUB–ASSY LH
(a) Remove the 2 bolts and screw.
(b) Rotate the rear door window division bar by 90° and pull
it upward, as shown in the illustration.
B59021
11. REMOVE REAR DOOR QUARTER WINDOW GLASS LH
(a) Remove the rear door quarter window glass.
NOTICE:
Do not damage the glass.
(b) Remove the quarter window weatherstrip from the glass.
2004 COROLLA (RM1037U)
1847Author: Date:
75–22
–ENGINE HOOD/DOOR REAR DOOR
12. REMOVE REAR DOOR GLASS SUB–ASSY LH
HINT:
Insert a shop rag inside the door panel to prevent the glass from being scratched.
(a) Open the door glass.
(b) Tilt the door glass and disconnect the roller of the regulator from the channel to remove the door glass.
NOTICE:
Do not damage the door glass.
HINT:
Pull the glass upward to remove it.
13. REMOVE REAR DOOR WINDOW REGULATOR SUB–ASSY LH (W/O POWER WINDOW)
(a) Loosen the 4 bolts.
NOTICE:
When the bolts are removed, the rear door window regulator might drop and be deformed.
(b) Remove the 4 bolts and rear door window regulator.
14. REMOVE REAR DOOR WINDOW REGULATOR
SUB–ASSY LH (W/ POWER WINDOW)
(a) Disconnect the window regulator connector.
(b) Loosen the 4 bolts.
NOTICE:
When the bolts are removed, the rear door window regulator might drop and be deformed.
(c) Remove the 4 bolts and rear door window regulator.
B59022
15. REMOVE POWER WINDOW REGULATOR MOTOR ASSY LH
(a) Using a torx wrench (T30), remove the 3 screws and the motor assembly.
16. REMOVE REAR DOOR LOCK ASSY LH (W/O POWER DOOR LOCK)
(a) Using a torx wrench (T30), remove the 3 screws and the rear door lock assembly.
17. REMOVE REAR DOOR W/MOTOR LOCK ASSY LH (W /
POWER DOOR LOCK)
(a) Disconnect the power door lock connector.
(b) Using a torx wrench (T30), remove the 3 screws and the
power door lock assembly.
18. REMOVE REAR DOOR OUTSIDE HANDLE COVER LH
(a) Using a torx wrench (T30), loosen the screw and remove
the rear door outside handle cover.
B59023
19. REMOVE REAR DOOR OUTSIDE HANDLE ASSY LH
(a) Pull and hold the release plate of the outside handle
frame, as shown in the illustration.
2004 COROLLA (RM1037U)
B57767
1848Author: Date: